My driver side running board not automatically close looking at the message cluster says rare left door ajar

tire pressure sensor light on

I did not see the knock sensor wiring

Truck sat for about a month battery was dead when I finally moved it hooked a jump pack up it fired right up drove great parked it later that night sat over weekend battery was dead hooked jump pack up everything had power but won't crank at all security light goes crazy mileage won't display numbers only dashes dash said data sensor error I disconnected battery charged it once hooked up it turned over twice but didn't start then back to data error and check temp on the display screen while the security light goes hectic also lots of clicking under hood if key is in on position

Cam sensors have no hot side

Was broken cruise control radar cable. Please help me with repair

Después de correrla y borrar la luz se apaga corriendo

My truck would t start so I changed the starter now my water an oil gauges won't read seems like I might not be getting fuel in but car turns when directly hooked up won't stay on

Clicking noise whenIaccelerate

The check engine light and the light that looks like a wrench are coming on recently and last night when I was taking off the ABS light came on the headlights got real damn in the engine stalled and then pick right back up and then stalled again I killed it and it crank back up normal and ran to town and back but on the way back ABS light came on and it stalled again

Reverse lights and reverse sensors stopped working

Bogging when driving down the road and the odd time dieing at a red light.

Has power with overdrive off but hesitates and Boggs down when going up hill with overdrive on and acts sluggish when cruising at low speeds with overdrive on. When you step on the gas halfway to the floor or more it Boggs way down before accelerating. I have replaced all 8 coils all 8 spark plugs fuel filter both evap valves and the fuel pump control module and cleaned the mass airflow sensor and dumped fuel system cleaner in the tank.

I can start my truck and it will idle fine in park or neutral
As soon as i put a load on it will start getting rough and stall out
In park it will idle for a bit till it gets warm then does the same as in drive
When i step on gas it will sometimes get the rpms to move but when i let off the gas the
Rpm stay up for a couple seconds then go down and stall
On diagnostics it will say im not getting a reading from crank phase sensor bank 2
Replaced sensor 3 times and still same thing

It started with jerks while driving; when starting gold y vibrates and then it normalizes. While driving it losed power as if choking a little, but now it got worse. It chokes while accelerating and sounds as if exploding, when I let go it keeps driving; if I accelerate again it does the same but it doesn't stall. If I turn it off for 5 seconds it works for 10 minutes and then it fails again. I alreadi cleaned the injectors, changed spark plugs, air filter, fuel filter, fuel pump, coils and their sensors. I've already had this problem for a year and they can't solve it, yesterday I scanned it and had air sensor error, but changing it didn't fix it.

My power mirrors, blind spot sensor, all climate control and door controls inoperable. Warning light comes on indicating blind spot issue... is this a fuse/relay issue? I can’t identify which of those to replace. Any guidance would be appreciated, raining cats and dogs here and driver window is down.

I have changed fuel pump fuel regulator checked relay crankshaft sensor camshaft position synchronizer I'm getting spark an getting fuel to the rail an I can spray starter fuel in it an it runs till starter fuel burns off

Seems To Skip But Feels Like A Shudder Have Replaced Plugs , #1 coil fuel filter trans And differentel speed sensors gas cap had a p0500 code and emission code

Check to fuel pump it's good change the crankshaft sensor I've checked the relays they are fine check inertia switch switch and reset it could the PCM wiring harness have issues where it clips into the computer itself

At the start, engine has a sound like hitting something, and after a couple minutes, warning low oil pressure, but back to the normal when I accelerate, sometimes appears the warning in high rpm (2500) and doesn't recover with the gas pedal. I have codes of crankshaft position sensor problems. I'm thinking to replace timing chain, but before start, any advices?

Have evap code cat o2sensors and htr

The fuse number 33 gets blown. I already checked coils and oxygen sensors, everything looks normal. There are no cables making a short circuit, and I also checked the gearbox harness. Scanning it gives codes for shift solenoid a and b, but the gearbox seems to work fine. What could it be?

So I bought the truck second hand and it cranks starts and runs very shortly and dies any fuel attempted on pedal and it indefinitely dies everytime idk what I should do and have mechanics background cleaned map and throttle body sensors fuse are good sounds like pump or getting power but again will start and it'll go to about 1500 rmp and then slowly die out what's the best route to fix this being budget friendly