Camshaft problems

Camshaft: It is inside of the cylinder head and it contains the cams. It is controlled by the timing belt.
Read more
More specific problems:
Related problems:

Top problems

Running very bad acts like it's not getting gas no acceleration SolvedSolved

Ford F-150 2001 Expedition 5 4 256000 miles
Ok started of only on inclines rough run back fire no acceleration sometimes die completely. Now it is permanent I have changed plugs coils camshaft sensor crankshaft sensor fuel filter. After repairs it runs idles great 5 minutes then back like crap
Expy from United States 4 years ago  
EX
3 reports 
Slick Rick from United States 4 years ago
Try cleaning your Mass Air Flow senser with cleaner from part store make sure it's for that senser n clean up throttle body real good with cleaner too. Also change out your PVC valve. I also had cooling fans not coming on as needed replaced couple relays n all is good now. Also check temperature control senser. Had same problems. Truck runs so much better now.
Solved
Best answer (according to Expy)
Expy from United States 4 years ago
I ended up changing fuel pump and fuel pressure sensor the 1 on tank ran good for a week rite back missing barley would stay running at all disconnected mass air flow sensor not a problem since and getting better gas mileage than ever 16.8 to 17.3 interstate
Comment

Crank no start

Ford F-150 1998 4.2 175000 miles
I have changed fuel pump fuel regulator checked relay crankshaft sensor camshaft position synchronizer I'm getting spark an getting fuel to the rail an I can spray starter fuel in it an it runs till starter fuel burns off
Jaybo from United States 3 years ago  
JA
5 reports 
Saint Evo from United States 3 years ago
Have you checked the fuel pump shut off switch. Should be on the passenger side wall under the dash...
Shawn from United States a month ago
Yes its no good had to jumpwire
Shawn from United States a month ago
But still does same thing
Shawn from United States a month ago
I can spray starting fluid in the intake an jt will start up for a sec
Comment

Act as if it’s going to die

Ford F-150 2010 5.4 V8 4x4 1941457 miles
Rough idling at times, acts as if it’s going to die backing up at times, just changes the cam shaft position sensor, getting 10.4 miles to a gallon, no code other than it saying check fuel fill inlet,
BlondeWithTheTruck from United States 6 months ago  
BL
1 reply 
ZanderZone from United States 6 months ago
Change out the VVT solenoids. To do this you, need to take the valve covers off but well worth it to get it running right. I bought mine off of Amazon. Make sure to order the Dorman ones...usually run bout $35 a piece on there.
Comment

Engine noise

Ford F-150 2007  100000 miles
Good afernoon, I own a Ford 150 fx4 2007 and recently I've changed both VCT (Variable Camshaft Timing), pinions and roller chains, a camshaft, spark plugs and coils. I have as well changed the oil but the engine is now giving off a sound at low revs, as if those chains were touching themselves.Even more, if I drive in reverse, the car usually starts trembling and, in order to stop it, I need to desaccelerate or stop it. No failure is provided by the computer, any ideas?
Ford from United States 11 years ago  
FO
1 report 
RANDALL from United States 11 years ago
The problem you are talking about corresponds to some chain failure.
Comment

Security light keeps flashing. Won't start

Ford F-150 2005 Lariat 5.4 v3 311000 miles
Replace camshaft position sensor replace the vcts drove the car go decent shut it off now it won't start instrument cluster lights are out and my security system won't stop flashing key on or off
Jimi from United States 3 years ago  
JI
1 reply 
Yankee from United States 2 years ago
Same problem I was told it could be the immobilizer
Comment

Camshaft position sensor

Ford F-150 2014 FX2 2WD 125100 miles
Power train system codeP0390 AND P0394
LarryP1976 from United States 19 days ago  
LA

Crankshaft position sensor

Ford F-150 2013 3.5 liter 130000 miles
My truck is growing a P0016 code. My scanner is dying it is a crankshaft position camshaft position correlation bank 1 sensor A. Does anyone know what sensor this one is exactly. And how to replace it. Any help would be great
1
Kevin Grant from United States a year ago  
KE
3 reports 

Running on Only 4 cylinders

Ford F-150 2008 Truck 4.2 V6  150000 miles
No fire on 3&4 towers on Coil pack,New coil pack,plug wires, sparkplugs, camshaft position sensor
davidchester215@gmail.com from United States 2 years ago  
DA
1 report 

I chanved the ca. Shaft sensors and now it dosent start. But first ans

Ford F-150 2008 5.4 l 2775365 miles
So I blew about and it ripped the wires off of one of my camshaft sensors and then it started running funny so forth kept kind of driving a little bit and then I went and changed them out and it would start a little bit but not run well and then all of a sudden it just doesn't run even try to start it tries turning over but it doesn't spark go wrong wrong spark at all
Sirrush from United States 3 years ago  
SI
1 report 

My Ford F-150 bogs down at stops

Ford F-150 2007 F150 lariat 5.4v8 275000 miles
So I have a Ford F-150 and I have literally replaced both camshaft position sensors the crankshaft position sensor I have also replaced the fuel pump driver module I've replaced all the spark plugs all the coil packs and for some reason it's still bogs down when I come to a stop it will bog down and start to sound like a diesel does anybody have any suggestions
Don swanson from United States 4 years ago  
DO
18 reports 
Problems with a F-150? Share them
Submit commentCancel
Submit replyCancel