The brake lights don't come on when I push on the brakes, the horn does not work and the shifter does not want to shift from part. Has anyone had this issue before?
Thanks in advance

Did a clutch change along with the master cylinder and slave cylinder. Installed the new neutral safety switch and after 2 days it quit working. Could tow and manually start truck no problem but not start with key. Removed and reinstalled the switch 4 times and no luck.

My truck was running ,while it was running I attempted to plug un a scan tool when I did the truck made a ding noise and I killed my truck attempted to start it again and nothing happened no click from the starter or anything I changed the ignition switch, the clutch safety switch still nothing ,I checked the starter solenoid and it works properly what is my problem

Ignition/run circuit short to power, safety belt lamp circuit short. Where might these all com into contact?

Air bag light is on the code is LFC 41 censor were i s location on the truck. I need to no were it locationed on the truck

Abs and break lights stays on

I am having issues with the air bag light flashing when setting and driving. What could be the problem?

My abs module burnt a small hole in the top of it. Smelt bad and was smoking wondering what this could be.

Fuse keeps blowing on the #20 fuse for the power door locks. Any clue as to why?

I replaced the engine for a 2007 with only 67,000 and transmission as well, the Abs turn on,All lights dim big time,then they will go to normal off and on, also the break light stays on

I just had to swap trans it drove fine than it like got hung in between gears even in park. It had Ben totteleda few months before in the front end and I never fixed the airbaggs the light flashes on dash. Is there a chance that it has to do with that because the transmission I just took out just lost reverse but everything else was fine but new tran now won't go into reverse and is hung in forward gear even when in park

Ac fuse blowing, unplug high side pressure switch fuse doesn’t blow, unplug the ac plug also and fuse blows again. Some how someone is gaining access to my door locks and. Not setting off alarm , allowing them to open my hood and do things to my electrical eg. Grounding out my system causing a short blowing fuses cruise stopped abs light came on now engine has misfire but no engine light. I just replaced and programmed the computer now a lot of things aren’t working right

Both doors will lock but not unlock and the remote will lock and unlock any ideas

My rear left passenger door will not lock/unlock when the door is closed. It will lock/unlock when the door is open. I replaced the actuator already and this problem is still occurring. No other doors have this problem.

The ABS indictator warning light stayed on... Anybody knows what can cause this?

Doors will not lock or unlock with key-fob. Installed new battery in key-fob. No change.

Both fobs won't open or close truck. New batteries in fob. All doors lock and unlock properly from the arm rest switches

How is best way to trouble shoot?

I have a 2012 Ford F-150 5.0L with an issue where multiple warning lights come on at the same time: ABS, AdvanceTrac, and Check Brake System. At the same time, the speedometer stops working, and the truck loses some power or goes into a limited performance mode. The problem appears while driving, not just at startup. Brakes still function, but I understand that ABS and traction control are disabled. I scanned the truck and found a P0720 code (Output Speed Sensor). I want to understand what could be causing all these systems (ABS, AdvanceTrac, brake warning) to fail together. Could this be… Read complete

Abs lihjt came on what does that mean

The power running board on the driver's side would deploy sometime. More often when the truck was running. Then it stopped working. Then the power lock on that door stopped working. I put a new door latch in. Same problem. The running board does make a retracting noise when you shut either door. So I think the retracting part would work. I have looked at some of the wiring but I haven't found anything yet. It's very difficult to get to the wiring in the kick panel and between the door and where the wiring goes inside. I think it's a broken wire or more that one. I just don't have a wiring diagram to say what would cause both problems, and are they related?

Battery corrosion is very bad

Abs light is on in the dash.

Whenever I turn the truck on, when I start driving it, for the first few stops the brake catches as if i were slipping on ice. However if I pump the brake, its fine for the rest of the drive. Also, the ABS turns on whenever I reach 10-15mph after I start driving. A few other things that may correlate include the speedometer not working and my 4x4 not engaging, thought not positive. Ive replaced the calipers, pads, speed sensors, and 4x4 actuators. My dad seems to think it may be the abs module, but wanted another opinion. Thanks in advance