The Climate control loses power sometimes the lights flicker on and off. It worked 4 days straight and the next day no power. I checked the fuse and it's fine. Any other fuses that may control the power to the climate control. Does the ECM have any control of the climate control module?

When the truck goes over 4000 rpm the check engine light flickers for about 20 seconds, and at that point the truck loses acceleration and then it goes back to normal. The error codes I have are P0300, P0302 and P0306. Thanks for your help!

Truck loses power while going down road and pushing on gas pedal don't help or do anything then truck dies

When I reach about 35mph the engine begins to Rev up and will not get up to speed limit and if I happen reach the speed limit on a strait stretch it will slowly lose power and drop to 40-45mph and just Rev when I try to accelerate

Got the truck yesterday was running a little rough check engine light is on took it to auto zone to have it tested its throwing codes P0010, P0020,P0345

When I start my f-150 it idles fine when I start driving it shifts and has power but after 20 miles it begins to lose power,I'll stop turn it off for about 5 minutes start it up and drives fine for another 20 miles and loses power again

Loses power if i turn off overdrive i get power back

The wrench symbol came on and the truck lost power and the a. C. Quit at the same time could this be a fuse issue

My truck starts normally, but as I'm accelerating it starts failing, the more I accelerate the more it fails, it loses power, the check enging light and a wrench indicator light come on, and while driving uphill it overheats. Please help me!

Replaced fuel pump but still get signs. It's a fuel pump. Think it's fuses. Loses power, Dogg's out, acts like transmission out, I have to manually change gears for it to try and go, backfires under hood also during all this. Then after a spell it runs fine. Unless gas is gone. Then it's hard to start have to add are lease half tank bang on it and constantly spray starting fluid with pedale to medal then after three cans starts. Does this Only when a quarter to none of gas in the tank left though. They say catalyst converter are clogged up is why ts doing that.

While driving the engine just lost power. When you depress the acclerator it was as you are not getting any fuel. I had it towed to a shop, the shop said they diagnosed the problem and it was the fuel pump, it was not getting the right amout of pressure. They replaced the fuel pump. When I picked up the truck it had a little rattle when changing gears, the mechanic said that the computer may needed to be reset! Drove the vehicle for a day and it shut down again with the same problems. Had to have it towed back to the shop.

Got a p0010 code bank 1 changed can sensors got p0044 p0045 all bank 1 changed bank 1 cam sensor connection got same 3 codes truck still running like a top but same 3 codes changed plugs coils cam and crank shaft sensors vvt solenoid on bank 1 and 2 changed oil Bam same three codes bank 1 bit now truck cranks idles perfect but lose power and shutters on acceleration no chain or phaser noise go easy get it up to good rpms just on acceleration or hills any idea I'm at a loss just put new rear end last month

Things i have replaced and meticulously cleaned/ made sure the connection was good: New alternator New battery New solenoid relay New positive battery cable Grounds were all checked and cleaned no breaks or cracks. Terminals were cleaned and greased Things i checked/cleaned Starter motor is good, just got it tested and its only a year old. All ignition and battery related fuses under the driver side dash. My problem: When i mess with the positive wire the truck gets power, then i try and start it and it wont turn over and totally lose power. Then i put my battery on the charger and its ma… Read complete

The truck has the check engine light on, but when I start it and accelerate it I get a wrench warning light and it starts failing and loses power, and the AC stops working. I had that problem before and using a carburetor cleaning product on the admission fixed it for a long time, but now it happened again and I can't fix it.

Truck loses power intermittently when going slowly up a steep incline, lunging and surging

Also parking brake light will not go off, and cruise control stopped working because it thinks the parking brake is set

My brakes feel like they are sticking and it loses power when I push the gas petal

I if it idle for a min it will lose power and is real sluggish then engine dies out an for some reason I can't get running light in the back no plow fuses

When wrench light comes on the steering becomes tighter and wrench light stays on. I don’t lose power except cruise control will shut off if I have it on. Wrench light goes away if I shut truck off for a bit.

Was driving & the symbol popped up, looked it up and it said it was the drivetrain etc. Lost power while driving & wouldn’t shift into gear.

What does it mean when service advancetrac comes on in a 2011 ford f150 and it loses power going up a hill and doesnt want to go It is using oil like crazy but it isnt leaking or coming our of the exhaust we took it to a garage and they said its burning oil on the inside of the motor we need help

It's running hot and delayed shifting and loses power