Makes a noise almost like when you’re on the highway, and getting out to the side. It has those things that wake you up if you falling sleep, and vibrates. Just like if you run over those rumble strips, but it feels like it’s coming from my rear tires.
I was changing My battery when I touch the side panel and I made a spark, and now I lost my radio AC headlights, my intermediate flashes with the security light, borrow windows don't work, sunroof don't work, turn signals to not work. I've checked my fuses and relays and I can't find the problem. Can anybody take me to the right place? Thank you
I am losing all power electronics and engine. Complete shut down. Then i will get all power back after sitting a few minutes. It starts up and everything works fine. Engine runs good and electronics work fine also. I just don't know when its going to happen, dont want to lose all power while driving. Also i put a new battery in so its not the battery. Any ideal what wrong.
Im not 100% sure, but on my C5 corvette, when the Freon gets low it will only blow cold on the passenger side. I’m assuming your probably low on refrigerant!
I have a 2016, and I’ve been chasing it for a while. I have redone my whole front so far. All is left is the inner tie rod and cv axles. But I notice it in the rear more
Goes down the road fine till i get to about 45 50 then kinda cuts out the throws a random multiple misfire after i did dod delete. If anyone know what this is i would greatly appreciate the help.
Service engine came on. Then instrument panel displays power lose. I replaced all of the sensors on my engine. Replaced ecu, throttle body control module and the connector, fuel injector all 8 , 8 spark plugs, and plug wires, fixed electrical short in the wires2 inches from BCM. It turn over but does not start. Im going to replace the fuel pump next. Any ideas I had the ecu programmed by a dealership. Cost 150 dollars. Crank no start. Dealership said replaced the Bcm. I did also reset the bcm to my truck. Security light went off also.
Ok so I have a brake problem when I push the brake pedal it goes to the floor I've bled my brakes numerous times changed the front caliper changed the master cylinder an brake booster grommet and valve made sure brakes fluid is full at all times no leaks brought two different bi directional scanner only to have them not be able to connect to vehicle not sure if it the abs module not working any ideas
Did you ever figure out the problem my guess would be the brake box underneath the truck either that or the short rubber lines that run from calipers up to fitting right behind the tires
Tengo Silverado 1500 2018 casi siempre la traego cargada con una traila pero hace dos semanas me salió la leyenda que se calentó la transmisión y ya no quiso avanzar, esperé a que se enfriara solo así avanza, ya cambié aceite pero se sigue calentando, no aguanta mucho alguien que pueda ayudarme
Whenever I drive up hill or at an incline driving 30 mph or faster my truck will have an inconsistent slight shutter or vibration that I feel in the seat and floor( when driveing on highway doesnt happen at all or very rarely). There isn't really anything else that will trigger it like specific rpm or specific gear(im sure it could be the lower gears if it is transmission). Ive changed the driveshaft u joints, serviced transfer case (it was slightly dirty and no metal fragments), checked the diff fluid( no metal fragments and fluid looks good). Looking for any information on what it could be or where I can find a repair/maintenance guild for my vehicle? Any help would be appreciated