Can't shift out of park, stepped on brake pedal with no success

My van started bucking when driving in reverse and suddenly stalled. I've changed: the pump, the discs, the turbine, valves body, sensors, ignition pump, oil. And after that, the bucking when in reverse stopped but it has started having problems when driving forwards. It is having starting problems, seems as though the gearbox slipped and, when driving, the gears won't change properly.

Motor starts stalling out @ 4000 rpm when accelerating wont shift into High just holds below 4 000

Brakes leaked fluid, transmission shifts hard, loses power going uphill, loses power in lower gears, truck also makes a squeaking noise

Hey guys, quick question! I have a 2006 dakota Awd 4.7L. The transmission temp light randomly comes and goes. I have no sign of an overheating transmission. It's not discolored. It doesn't smell burnt, not shifting hard or late shifts like it should. If I turn the truck off and turn it back on it usually goes away for a while. Anything I should look at!?

Not wonting to shift gears and get stuck in one gear and when it's like that trying to pull out onto a highway is very hard cuz it wants to kind of like quit running and plus it uses ton of gas I can put gas in say on Thursday and not hardly go anywhere and my gas hand is almost on half just seems to be a transmission issue and is it a safety hazard when it comes true the transmission

The automatic transmission did not change from second to third gear. I was told it was the camshaft's sensor, it was repaired and worked properly for three months. It has now stopped working completely, all of the gears at the same time. The scanner indicates high pressure and a low in transmission, and the code it provides is p1745,

My Dodge Dakota 2007 is having steering failures. The pump sends a good pressure but, when connecting the hoses to the box, the steering makes a sound and it remains hard. It is really worrying me as the gearbox was renewed after 40000 km, and also because corrosion bubbles are appearing in the painting. Even more, the computer sometimes fails as if there were a problem in the spark plugs.

my engine got too hot and while it was overheating when I pulled over, it made a loud noise and then stopped when I plugged when I let it pull down and turn it back on now it won’t start. It turned over, but it won’t like there’s no spark to it. I plugged in the obd reader and it said p0601 code PCM issue.

Transmission not shifting properly

When riding down the road it starts bucking and searching like it's running out of gas change positioning sensor and still doing it again runs good for a minute and then goes right back to the old way

Hello all, This is my first posting. I hope someone can give me an idea of what to do, or what to replace to fix this thing. Also with all these problems is it safe to drive, or not. I have an 82 yr old mom that is missing doctors' appointments because of this. I have cleaned all accessible grounding points, tie-wrapped down the 3 connectors of the VERY recently installed PCM, I have been trying suggested fixes found on this blog but nothing has worked. Issues became visible when the truck began to stall, at very inopportune times. Crossing intersections, on the freeway, or just idling. BTW, I… Read complete

Starter drags and barely turns motor over. It tuns over like the battery is dead. If I hold the key in the start position it drags on then starts. New starter is acting like the old starter I replaced.

I'm going to get a lot of Mopar people mad but I'm looking for help with a 2004 Dakota that I put a small block chevy in. My issue is the wireharness, I can't find anything that can go from Dakota to old chevy... I'd like to plug into the factory harness to use dodge gauges and key ignition !! HELP

When truck sits and idles for while it won't shift from 2nd to 3rd. I have to turn it off and let it sit for while and then it will work again