Multiple warning icons are active (sensor/ assistance systems)

The car started idling rough, poor performance and low fuel efficiency, so I checked and noticed that the 02 sensor socket was not connected! I then connect it and start the car, it runs for a while and then off. The main light was off as well, so I couldn't restart it, initially I thought it was battery, after tracing, I noticed the main light fuse was blown off, so I changed it and start the car, after driving for a while ,it happened again.

The car is idling erratically, engine shutting down when you press the clutch down RPM drops to zero

The knock sensor is broken so we tried to weld it , after we tried to move but it's losing power

I don’t have my front bumper and those sensors won’t go off on the dashboard

Car does not go faster when accelerator pedal is depressed

The fittings that connect to the head and there are two of them are made of plastic which obviously being plastic and so small are both broken probably due to engine heat and the hoses connected to them at just sitting there and its running rough on idle and when the aircon is turned on. If I know what these fittings are called I can order new on ebay so Im looking for the name of the parts, I cant just order vacuum hose engine sensors they must be called something, widget, gizmo, etc?

The rear reverse sensors operates continually without other vehicles or objects around it, when driving and when parked with the ignition on

Hey guys
I am having issue with my Tire Pressure Monitoring system as i have good enough air in my tires but after a little while (15 minutes) the tire pressure sensor blinks and stays on. I reset the light by holding the button but it again turns on after a while.
What should i do ?

Hi, my engine management light comes on whilst driving maybe once a week. Then goes off after I restart car. I have had the camshaft sensor replaced as this is what the fault code was signalling. However, the light still comes on but not so often as before. I have had many different diagnosis from garages /mechanics (without seeing the car). I have been advised to get the serpentine belt changed, timing chain slipping, wiring fault or sensor is misplaced. Can anyone shed any light without me having to spend a fortune please? It is a vvt-i petrol engine. Thank you

Toyota dealership suggested problem may be "sensor" at time I delivered to dealership. Toyota replaced clutch switch Assy. According to invoice. Car starts a little better (without pushing in pedal so many times) but still will not start at times - e. G. , have to push clutch in several times(3 to 4) and while holding pedal in, I rotate my foot on the pedal.

Air bag lamp is on always,i am already check all sensors cables , get out battery (-) negative wire and connect it again.

I have a problem with the fusebox, im having problems with my toyota corolla 1.8L year 2008 1zz-fe engine with sensor like crankshaft, camshaft, ignitions coils, vvt valve, and i change all of them, and it works fine, but in all that maintainance work, the engine fusebox was checked and with the manipulation the car start getting problem and stop working, it cranks but wont start, and doesnt light the check engine alert, so the car computer doesnt get electric current, so checking the underneath wires i notice that some cables are loose and a bunch of white wires with black line fall off, the… Read complete

Hard start at morning or after shut off an hour happen same thing ? I change spark plugs ,cooln sensor, airflow senior ,injector too but same am very tired this car but I like it ? Please help me ?

The last couple weeks my battery light will flicker for a moment then come on solid followed by all the dash lights and the loss of function in the speedometer. The brights come on and power steering goes off along with traction control. When this happens I pull over and turn the car off, restarting after a minute or so. This clears all of the dash lights and restores function but leaves the check engine light on and the "trac off" light next to it. The code it throws is a p0500 which is for "Vehicle Speed Sensor". I replaced the alternator a couple months ago, the battery last week, the serpe… Read complete

The ABS light turned on, I cleaned the front wheel's ABS sensor and it turned off. As I started the car again, the light was on, I removed it and the next time I started it was on once more but this time there was no way I could remove it. How can I reset the ABS system?

I have a 2016 Toyota Corolla L sedan. The engine temperature previously went all the way up to the maximum, and the A/C stopped blowing cold. I took the car to a repair shop, and the following parts were replaced: * Cooling fan * Radiator * A/C condenser * Thermostat * A/C compressor * Radiator cap * Water pump However, the car still occasionally overheats, mostly when the engine is running but the vehicle is stopped in heavy traffic with the A/C on. It usually does not happen while the car is moving. I have noticed that the cooling fan turns on, but it does not seem to run fast or strongl… Read complete

In toyota allion 2003 -evaporator temperature sensor where it's located

Using a scanner it shows its the MAF sensor but on testing the sensor its ok. Clearing the fault it returns after a few minutes

Car run fantastic. Out of no where, all dash warning lights are on. ABS, Brake, power steering, airbag, Speedometer and OBD port won’t work.
I have changed every fuse. I have changed relays,
I have unplugged the ABS module and tested the OBD port still no communication. The port actually has power but no communication.

I changed the steering angle sensor and clock spring. I cannot calibrate them because the OBD port will not communicate in my tablet cannot calibrate it. I’m freaking stuck. What the hell do I do? How do I get my OBD port to work?

My car always stop engine when I drive for long like 1hr. We have replaced, cold start sensor, coil injectors, fuel pump, fuel filter, crankshaft and ignition switch

My Car has pick up issue, i checked the MAF sensor earlier which was repaired again after a fre weeks but the oroblem is still there. Corolla Altis 2010 (pakistan assembeled) 1.8 engine.

So the car would swing over as soon as it starts it would run for 1.5 secs then it shuts off if you start it with your foot on the gas it shuts of right away. Changed fuel pump ,check computer (good), tried different idle air sensor same thing. If i start it on trottle boddy cleaner the car starts and you can rev it.

Car sputters and hesitating to accelerate. I've changed the coil packs, spark plugs, PVC valve. Mas sensor, gas pedal acceleration sensor, throttle body and sensor, fuel pump and fuel filter, and cleaned the fuel injectors. And reset the ECU on a number of times.

Transmission Fluid Temperature Sensor Circuit A high

Input/turbine speed sensor A circuit no signal

Al acelerar el carro no tiene fuerza ya le limpie el. Sensor map cambie bujías filtro de aire le limpiaron el sensor de oxigeno el que está a un lado del catalizador, cuál puede ser el motivo que hace que no tenga fuerza?
Saludos

Al acelerar el carro no tiene fuerza ya le limpie el. Sensor map cambie bujías filtro de aire le limpiaron el sensor de oxigeno el que está a un lado del catalizador, cuál puede ser el motivo que hace que no tenga fuerza?
Saludos

01 -Revisando hay un inyector malo se cambio por uno nuevo, tiene dos cables uno de corriente y uno de pulso pero los dos tienen corriente.
02- dio problema con el sensor de velocidad se cambió pero aun sigue con la misma molestia