I can start my truck and it will idle fine in park or neutral
As soon as i put a load on it will start getting rough and stall out
In park it will idle for a bit till it gets warm then does the same as in drive
When i step on gas it will sometimes get the rpms to move but when i let off the gas the
Rpm stay up for a couple seconds then go down and stall
On diagnostics it will say im not getting a reading from crank phase sensor bank 2
Replaced sensor 3 times and still same thing

I just bought this 05 f150,the guy I got it from said he replaced the fuel pump , coils, spark plugs, it will start if you spray it with some starting fluid and will run between 5&20 minutes then dies and will not restart for several hours even with starting fluid.

After starting and engine starts to warm up the idle speed starts to lower to the point when your slowing down the engine dies. Engine will start back up fairly easy but does not want to idle right. You can take off but when you start to slow down and your rpm lowers the engine will die.

My vehicle jerks and stalls while driving, usually when I speed it up. I've already chan the gas filter, the catalytic converter, the gas regulator, spark plugs, wiring and coils. Even though the jerking problem is not as worse as it used to be, the car still stalls. Can anyone help me please?

I had a new Battery installed and since the Radio Shuts Down after turning of engine.

I drive around at least 2 hrs or more and 06 f150 you go to mash pedal down to pull out or to go up hill or to pass and truck just shuts off no power anything no lights nothing. I've replaced throttle body, fuel pump control mod. Up by spare tire. Ive replaced fuel filter. Thermostat, air filter , sill have this issue I really would like to drive my truck again. What else should I fix.

I started to leave from a stop sign and kicked it down a little and the truck stalled and the low oil pressure light came on. I pulled over and checked the oil it was fine. I then went to start it and it started fine and the gauge for oil pressure was normal. I drove it home about 2 miles. The next morning I went to start it and it will turn over but will not start.

HELP : my 2010 f-150 truck stalls when I put in gear

Got gas and then the problems started. Changed out 5 coil packs, all new plugs. New purge control valve. New fuel pump. Checked fuses and relay. Truck will start, rev up and then die. I hear a clicking sound near the kick panel fuse box just before it dies. Snap-On scanner is showing Code B10F1

2009 ford f150 lariat 4x4 5.4 3v

First start after sitting overnight. Rpms go up the down right away to about 300 then back up to about 900. Put truck in reverse and truck stalls out. This does not occur every time. Does the same when I put in drive

Truck choked down & died. Then cranked and ran. Now engine turns over but won't crank.

Truck loses power while going down road and pushing on gas pedal don't help or do anything then truck dies

Rough idling at times, acts as if it’s going to die backing up at times, just changes the cam shaft position sensor, getting 10.4 miles to a gallon, no code other than it saying check fuel fill inlet,

Code for all 8 cylinder coils, no spark needs to check fuse box

Turn off truck battery dies but there is a clicking noise coming from the fuse box

Engine was running fine while warming it up on a cold. After 15 min of running i was about to put it in gear and it just died and would not refire. I began to diagnose by checking for spark at plugs, none, fuel rail pressure, none, all the fuses are good and the breaker for the fuel pump is good. I have power on 1 side of the ignition coil but none on the other when cranking over. I have no power to the fuel pump but i have it at the fuse and relay. After it died I thought I smelled smoke in the cab but cant find anything burnt. I removed the ECM and it smells a little like it but i'm not sure… Read complete

My truck wants to stall at low speeds. When I put the truck in neutral then Rev up the engine and pit it in drive it runs fine until I slow down again then it does the same thing. The garage changed the cam sensors but that didn't correct the problem. They suggest increasing the velocity of engine oil and or putting synthetic in to increase the oil pressure. Any thoughts?

Regards,
Ian

Battery reads 12.7V not running, 14.7V running with lights on. Most days I have no issues. Occasionally I start it up fine drive 20 or 30 minutes and make a stop. When I get back in the battery is completely dead. I can jump it and then it runs great for several days before doing this again.

While driving at various speeds, truck stalls occasionally. Rough idle and loss of power as well. I have replaced-fuel pump and control module, plugs and COPs, cam and crank sensor, sent pcm out for testing(good), and pcv valve and tube, cleaned throttle body, had cats looked at(good). Sometimes it happens daily, sometimes I can drive it for a month. I’m ready to scrap it! Advice please.

My engine work perfect when is cold,but after some time when is get hot start stall.

Engine keeps stall
Ing when put into gear

My Ford F150 stalls when I'm stopping or approaching a traffic light. It only does it when the air conditioning is on. I'll be very grateful for any help.

Stall while driving with low oil pressure

Turns on fine dies out after a while of driving and doesn’t turn back on after like 30 or so

Active codes p0010 p0013 p0020 p0023 p0201 p0202 p0203 p0204 p0205 p0206 p208 p0443 truck has short crank no start issue at this time. Battery weak. 1 my key for vehicle dose register for chip. Interior fuse panel in good condition with all plugs attached firmly. Believe I have good 5v on random 3+ wire harness connectors tested. Visually inspected engine harness no signs of damage to plugs or wires. Inspected under hood fuse panel nothing is burnt or visibly damaged. Found no power at fuse 75 (PCM voltage power 1) power under hood Can't confirm oil level via data link but manually can confir… Read complete

Put the truck in reverse in the engine bogs down and installs out

When the truck is on but at a complete stop and tuning the AC on the truck will vibrate then stall. At speeds between 1-15mph turning the AC on will stall the vehicle. Driving above 15mph there is some power loss but the truck will run until it drops to a lower gear when nearing a complete stop.

brake light won't work after installing a new bulb

Horn stays on when fuse is put in fuse panel and does not shut off until removing it

Replaceed battery,atlernator,starter
Fuelppump all new