No funciona el pedal del acelerador cuando enciendo el coche y están inestables las rpm,en ocasiones no aselera a mas de 3mil revoluciónes, enciende el testigo del EPC, y alto consumo de combustible lo apago y lo vuelvo a encender y funciona normal pero me lo hace más seguido

Exhaust bank sensor 1 location

No enciende el ventilador del motor

Vuruntu sensörü tesisatı hangi pinde araç beyninde bilgisi olan varmı kabloyu bulmakta zorlaniyoruz beyin kablosunda hangi pine takılıyor lütfen yardımcı olun vuruntu sensorun tesisat kablosu icin yardimci olun bulamıyoruz kabloyu

Buenas noches quisiera saber cómo va conectada la pacha del sensor árbol de levas ya que al conectarlo se me apaga del vehículo agradezco su colaboración

Coolant sensor light on sensors have both been replaced

Speed meter is not working and showing the indicators

Hola buenas noches amigos tengo problemas al conectar nuevo arnés del sensor de cigueñal CKP es un jetta a3 2.0 me podrían ayudar el arnés genérico trai azul,negro y naranja y el cableado original trai verde,negro y rojo no se como van conectados por error perdí el arnés que le quite y no recuerdo como conectar dejo fotos del arnés nuevo y de los cables que ya trai original el jetta saludos

fallas de acceleracion al iniciar el movimiento

There's a light on the panel that according to mechanical, I need to replace this sensor.
Where can I find it in Brazil?

I have a Jetta A 4 2002 and, when driving, it suddenly jerks, EPC and oil indicators turn on and it loses power until it stalls. I try to speed it up but it won't answer properly. Only after 20-30 minutes the engine will start again. The car has been tuned, the battery, oil pump and air sensor changed but it keeps doing the same thing. Can anyone help me? It really worries me when I'm driving and it suddenly stalls.

The car has been sitting for 8 months bought it for a very good price. I have good fuel pressure 35 , I have fire to all the coils ,plugs look fine, all fuses look good, but nothing just turns over seems like no fire or fuel. What should I do next? Also it had a po721 service code which I knew about I need to replace the output shaft speed sensor. No other codes

The car starts but idles rough. After driving it a few feet the accelerator will stop working. Shows engine codes for a cylinder 2 misfire and a MAF issue. Have tried changing spark plugs, coils, sensors and gaskets and nothing seems to resolve the issue.

It dies when idleing or somethines while driving. At first it had issues starting had to try key a few times now it starts but dies ive changed fuel filter did an oil change i replaced the camshaft sensor even the o2 sensors i dont know what to do

I have a 2019 Volkswagen Jetta 1.4 TSI with an 8-speed automatic transmission. I have been experiencing a jerking/bumping issue when shifting gears. The main symptoms are: 1. A noticeable jerk when shifting from N to D. 2. A jerk when shifting from 1st to 2nd gear. 3. A jerk when shifting from 2nd to 3rd gear. 4. A jerk when downshifting from 3rd to 2nd gear. 5. Sometimes there is also a jerk when downshifting from 4th gear. 6. The problem has been present for about one year. 7. The transmission fluid has been changed several times, but the problem is still present. 8. Different mechanics ha… Read complete

Ya le reviese la bomba de gasolina y si funciona, rtambien limpie el sensor posicion de cigueñal, limnpie el cuerpo de carburacion y cambie el filtro de gasolina y sigue sin prender

Replaced wheel angle sensor power steering module can't scan reset recalibrate

Falla en el sensor no activa la valvula de alivio y el carro no corre a mas de 40 millas

Oil pressure comes on when vehicle warms up around 30 km driving sometimes throw the engine light on with code P0341. Camchaft sensor problem. Camshaft sensor was changed twice. Cannot figure out what the problem is. It does it when RPM is around 1200. Says engine fault.

My car fan running all the way even when i has change both thempsensors

Check engine light flashing, when accelerating it hesitates, uses more fuel. I recently put a new radiator fan on and now it keeps throwing this code P2185

Check engine light is on i range the code it says map sensor and throttle body how do I fix this

Sometimes stalling when stopped or sputtering when accelerating from stopped. Comes and goes but get's more frequent in the drive. Got a code P0131 02 Sensor 1. I replaced it, same issue. I unplug the 02 sensor and it will run. I thought it was the harness on the vehicle and had dealership take a look. They did an overlay on it "as a start". They said it was done, I kept asking about the 02 sensor before pick up. "It's good, we drove it, etc.". After pick up about 12 miles later I stall/sputter. They say it's the ECM and Cat. Converter.

Looking for second opinion.
I've replaced spark plugs, wires, coil. MAF, MAP sensors. Purge valve.

Se cambio el sensor que va en la bomba de frenos pero sigue igual

Les codes d'erreur que tu mentionnes sont généralement liés aux capteurs de la transmission et du moteur. Voici une explication rapide pour chacun :

P173C & P173B : Ces codes sont souvent associés aux transmissions automatiques, en particulier aux capteurs de pression hydraulique ou aux solénoïdes de transmission. Ils peuvent indiquer un problème de contrôle de pression ou un dysfonctionnement d'un capteur de position dans la boîte de vitesses.
P0841 : Ce code concerne un problème avec le capteur de pression de fluide de transmission (TFPS - Transmission Fluid Pressure Sensor). Il indique que la pression relevée ne correspond pas aux valeurs attendues par l'ECU.

The car can lose power easily because of this wires who are not connected properly to the 4 pin sensor

Falla en sensor abs
Problem and abs