Having problem with ignition coil code po135 bank 2 replace coil still having the same problems check engine light stays on codes will not clear

1 put 2 engines in my trucks both not any connecting or fire on right side coils put in new coils new coil wire and enjecter

I put a coil new wire cap but it get spark get gas but don't. Strart

It will work good but start blowing hot air but the whole coil under the hood stays cold the top part and the bottom and the parts that runs to the air condition coil it don't need any freon and the fan works

My truck backfired and died while in motion, it restarted after a minute but i drive another mile and stopped and turned it off and now it will not start. It turns over strong, had fuel coming thru the fuel rail, i just replaced the ignition control module, the ignition coil, the distributer cap, the rotor, and the cam shaft position sensor after this happened a week ago and a week before that as well.
When i add fuel in the carb manually it still won't even fire. What could be the problem?

2006 Silverado 1500 4.3 v6 no crank, no start, no spark, no trigger signal between icm and ig coil, no pulse on signal wire from ckp to icm, odb2 coming on but wont connect

When trying to crank engine motor does nothing. No power to coils, fuel pump or starter. Can get the motor to spin by jumping starter relay pins #30 and #87. Accessories work.

Truck once warm will studer and fie or just die wait a few minutd and it will stsrt. Then sfter a few minutes it does it agai have changed coil icm plugs wires distributor cap and module. Also throdle position censpor cleaned throttle body. Could my catilatc converter by baf. Help have to go to work tomorrow.

I replaced the ignition pick up coil the ECU distributer cap rotor ignition coil
And still no start :( I am not getting spark to the spark plugs please help