Warning lights problems
Warning lights: Luminous indicator that is usually placed in the dashboards and warns about a possible problem.
Read more
More specific problems:
Related problems:
See owner's manual
Top problems
Oil light came on 1mint later will doing 100ks the car turns off cuts
2011 Mitsubishi Lancer 156000 miles
Car stops going at 100ks oil light came on 1mint after that it cut out
1 reply
3
BR
It is possible that the oil light coming on and the car cutting out are related to a lack of oil in the engine. It is important to check the oil level and add oil if necessary to ensure that the engine has sufficient lubrication. If the oil level is low, it is possible that there is a leak or that the oil is being consumed too quickly. It is also possible that there is an issue with the oil pump or pressure sensor, which could cause the oil light to come on and the engine to cut out.
Vote helpful
CommentUpstream 02 Sensor Code P0031
2011 Mitsubishi Lancer LANCER ES 140000 miles
I fixed all sensors but still getting check engine light
3 reports
Did you check your O2 sensors some cars have another sensor on the downside of the engine so you might have an Additional sensor that is out
Manuel Bautista from Belize 3 months ago
Where is the cabin filter for my mitsubishi Raider 2006, 3.7L located? I want to change it. Thanks.
CommentMitsubishi lancer glx 1996 , l have a check engine, when l don't push
1996 Mitsubishi Lancer 12000 miles
Mitsubishi lancer glx 1996 , l have a check engine, when l don't push gas pedal
1 reply
MitsLancer from other 2 years ago
I had the same issue, i just pushed the gas pedal full while I m driving and it disappeared .
CommentStarter sometimes spins but doesnt engage
2008 Mitsubishi Lancer sedan, manual 120000 miles
When i try to start my car, you can hear the starter spin loudly but it doesnt engage time to time, but when it does then everything works fine, i dont know if it has a relay or just a fuse, i need help, maybe switching it will help, ive changed two starters, one was paid for and the other for free because the old one failed but it still has the same problem.
3 reports
Car turns on but staus in limp mode after Battery change
2013 Mitsubishi Lancer GT 68000 miles
After replacing the brake lights and the battery, it worked flawlessly for a day or 2, then when i stopped the car gave me 3 errors , check engine, remove water from separator and engine overheating. After turning it on again, its starts normally but stays in limp mode(no more than 2k rpm). Error codes on OBD2 are P1590 and U0100. Checked all the fuses and they are working fine, but the car wont turnoff the console even with the key out. help please
2 reports
one coil pack cutting off
1998 Mitsubishi Lancer 4g93 engine 3210446 miles
if I drive on 3000 rpm on any gear one of the cool pack cuts off. I lose power .engine check light comes on and if I restart the car the problem goes
4 reports
Problems with a Lancer? Share them
