On the dash it show a gear with and exclamation mark at the bottom it writs slow down. When I engage drive it jerks terribly its not excelarating at all

Gear slow to engage when shift to drive

Transmission overheating, message says slow down overheating

Transmission engages gear 1. But cant move.

When I start the SUV it sounds like a gas powered model toy plane set to take flight. There's nothing obstructed, I changed the cabin filter. I was thinking it may be a fuse because last night my 2 headlights quit. My guess which I start from the easiest fix which would be check the fuses, from there could be a loose wire , ECU could need to be reprogrammed or fuse replaced. Has anyone else had this problem? I should probably put the obd scan tool on it. Probably wouldn't hurt to take the fuses out to see if any have to be replaced. Any suggestions are appreciated.

Replaced fuel level sender as that’s the code that came up, not working. Tested new and old sender parts, both pass resistance tests. Dash says maintenance required for fuel system, with CEL illuminated. Not sure what to test next. Code P0460 only. No other hidden codes. Reset codes after replacing part, obviously came back.

Put obd reader on but battery shows 12.7volts but obd reader shows 10.2 volts and won’t start

Cut some wires accidentally under my seat may have wet the harness on the gear shifter no crank. Feels like a immobilizer issue or key

I have a problem with the gear jumping out a second gear when dropping down gears I know there's a fall and a known recall for L200 but it's the third gear they've been saying at the dealership but they've never had a problem with the outlander gearbox 6 speed manual jumping out of 2 gear

Pinout for the 2008 Outlander transmission control Module