Automatic transmission problems

Automatic transmission: It switches gears without the driver having to do anything.
Read more
More specific problems:
Related problems:

Top problems

Obd port not have power SolvedSolved

Ford Escape 2001  50000 miles
What fuse would cause the obd port to not have any power i have check all the fuses none of them say anything for obd port
cameron from United States a year ago  
CA
7 reports 
Solved
Best answer (according to cameron)
cameron from United States a year ago
I think it’s a simply problem
Comment

Transmission on escape

Ford Escape 2014 Escape. 1.6 eco boost  211100 miles
Transmission when I put the shifter in a gear it dies but it starts in neutral and park both and erratically hard shifting and over spun transmission fault light comes on vacuum line on drivers side hard plastic size of pencils is broke off keep getting incorrect ratio on numerous solenoids erratically rough shifting wont shift at all replaced bushing but s till feels like the gears are a little off
Silver from United States 5 months ago  
SI
1 report 
Dillan from United States 5 months ago
Mine does this too have you figured out what the problem is? It's throwing a code about the torque converter clutch solenoid but I cannot for the life of me find who sells it
Comment

Hill start assist not available abs and traction control light on

Ford Escape 2015 Se 136000 miles
Car runs and drives great. Not had any problems till now. The obd port doesn't work. So I can't have the system checked. But I have changed the breaks and abs sensors. And still the same problem.
ToxicCupCake from United States 3 years ago  
TO
16 reports 
Freedom from United States 3 years ago
My BlueDriver claims that both rear wheel speed sensors have wrong part installed. I've read that i need to remove and clean, cross reference part numbers that are etched on them, also check wiring and anything else related to them. I haven't attempted this yet. First, i need to fix the battery drain issue and then emissions issues, then the abs will get its turn.
Comment

Electrical, random no start trans position sensor low voltage

Ford Escape 2013 Se 2.0 4x4 220000 miles
Was driving and car shut off. Tried plugging in scanner and it had power but wouldn’t communicate. Ecm relay was clicking multiple times. Towed to shop. They replaced fuse box and now it will operate normal most of the time. There is a code for transmission range sensor that’s located internally. Opened up trans and replaced. No change. Car will randomly think it’s in D as soon as you insert the key to start it. Turn key off and on and will usually start. Sometimes have to turn key off and wait for the display to power off and then it will start. Also when shutting engine off it will engage starter for a split second and make contact with fly wheel to abruptly stop the engine.
Lost from United States 3 years ago  
LO
3 reports 
Bobby from United States 2 years ago
Yes mine is doing the same thing what Is it please
Lost from United States 2 years ago
Never figured it out. Just shut it off in drive and it doesn’t bump the starter and then place it in park and cycle thr ignition before getting out and it will start when get back in
KiKi from Canada a day ago
@LostIt was your fuse box and/or negative post terminal cable thingy... to know for sure, run the car in idle and push on the fuse box
Comment

Strong vibration when drving

Ford Escape 2018 escape in warranty 1.5 180CV 4138 miles
Strong vibrations when driving on the highway one every two times.
I feel that the vibration is caming from the automatic transmission
Charlie from other 2 years ago  
CH
3 reports 
Will from other 2 years ago
Vibración en el timón y ruido al lado derecho
Comment

Engine codes from the OBD: P1000, and P1260. O^2 sensor incomplete.

Ford Escape 2012 Black / 4 cylinder/ SUV 152146 miles
DMV inspection OBD failed. Readiness failed.
Wucherer from United States 4 months ago  
WU

Instrument cluster reads Drive in park

Ford Escape 2005 Xlt, 3.0L 230000 miles
I’ve tried replacing the ignition switch, the neutral safety switch, manually putting transmission in park (which it is in park), the shifter cable is in perfect condition, transmission is fine, but the instrument cluster will not read that it is in park, only in drive. I just got a nee cluster and installed it, and it still says it is in drive. I just help.
Jagen Sturgeon from United States a year ago  
JA
1 report 

En la palanca r o d tiembla el motor

Ford Escape 2014 Se ecoboss 65000 miles
En ocasiones cuando paro en un semáforo el motor tiembla en la D y tengo que ponerla en la N y cuando cambio a D en ocasiones se apaga y regreso a P y al ponerla en D se vuelve apagar
Prusian from other a year ago  
PR
1 report 

ABS lights on

Ford Escape 2007  368000 miles
The gearbox some times working fine and some times not with flashing od light
Ehsan from other 2 years ago  
EH
4 reports 

Constant engine check and O/D on

Ford Escape 2003 L3 216000 miles
The car fails to pull when driving on a hilly road and would overheat
FEP2 from Great Britain 2 years ago  
FE

Cant start and o/d blingking

Ford Escape 2004  250000 miles
My car have crank but cant start o/d linght blingking
AZIZUL from other 2 years ago  
AZ
3 reports 

Needs to be jump started

Ford Escape 2014 Escape 1.6 liter 95182 miles
My battery is 1 yr old but I have to jump start it sometimes
SlimWadey from United States 5 years ago  
SL
2 reports 

Won't shift to overdrive

Ford Escape 2005 6cyl all wheel drive 170000 miles
I was told a bad wheel bearing is why my 05 ford escape won't shift to overdrive
Mick from United States 10 years ago  
MI
9 reports 
Problems with a Escape? Share them
Submit commentCancel
Submit replyCancel


Find what you needed?

Thank you!