Epc light goes on car goes into a limp mode than you get no throttle, after switching the car on and the on than you get throttle but only for a short period of time than it does the same again can it be the sensor coming from the ecu

The car every time when i try to start it misfires nd it does rev I wounder what's the problem cos I don't know pls help nd it's not serviced accelerate does not work I don't know why help

The car is not having power on the throttle body it does not start unless I disconnect the throttle body

My polo 6 clp engine I changed spark plugs, injectors, coil pack and new throttle body and it still misfiring and acceleration paddle not working what could be the course?

My polo 9n has a high idle. I tried to clean the throttle body but the problem still persists.

In cold starts the polo of my gf shows EPC Light. When u drive the car for 5km and restart the car its gone and only comes back after one night of not driving, you can turn the car on and off as much as you want and you can drive however you want the light wont come back till the morning after in the next cold start. If its like 15-20°C + outside and the car warms up in the sun this also doesnt occur. The Gas Pedal and the Generator has been renewed. Any idea on this problem? Any experiences?

When the car idles it backfires, it also seems like it has no power and when you remove the throttle sense it idles normal

How to test or check when a car VW polo 1.4 trendline doesn't have power or when stepping on the accelerator it doesn't go anywhere or have high rev counter

My car suddenly stopped working and won't move, even though the engine starts completely normal. Whenever I try to shift gears, the corresponding gear indicator light on the dashboard—whether it's P, R, N, or D—just flashes continuously and nothing happens. There is absolutely no forward or reverse engagement at all. Interestingly, the accelerator works perfectly and the engine revs fine when the shifter is in Park or Neutral, but it does absolutely nothing when I put it in Drive or Reverse. It seems like the transmission has gone into problems.

When I start the car, it turns on and off on its own. Then, randomly when I drive, the EPC light comes on, and I can't use the indicator or the horn. Nothing on the steering wheel works.
This is after I replaced the throttle body because I was told it was faulty.

I had a epc and check engine indicator
Then i went to the mechanic mode i cleaned the throttle body by my self using throttle body cleaning then fixed the EPC light now disappeared but I noticed while scanning misfire is happening so one cylinder was not able to produce power only other 2 cylinders were produce power so i changed 3 spark plugs not a single piece i changed 3 spark plugs in NGK brand but the problem is still there then i have changed 3 ignition coils in same NGK still the problem is there what can i do... I forgot to said its 3 cylinder polo

Accelerator pedal feed back over the road

Replacing the accelerator pedal cable in a 2000 Volkswagen Polo diesel.