O2 sensor heater circuit bank 2 sensor 2 and bank 1 sensor 2 same problem i put new cats to pass smog and still check engine light for the o2 sensor help...

3 of 4 tire pressure sensors not working.

Over past 8 months my blind spot sensors have not been working. Every time I start up my truck the alert pops up “ blind spot sensor unavailable “ I’ve pulled battery and still have same issue. Anyone experienced this and have a fix?

El sensor de oxigeno está fallando, el check in está encendido

Replaced fuel sending unit but fuel level sensor still doesn’t work. Instrument cluster is good and plugs are not corroded.

I experience a not functioning door power Handel left side sensor? Plz any idea to how trouble shot this problem. Thx

So I have an intermittent problem with crank no start on the first try but will on the second and sometimes will start while struggling but will start very weak then run like normal. I did replace the crank sensor and fuel pump already. Also I have no lights or alarms on the dash. Anyone else having this issue?

2002 Dodge Ram 1500, 4.7 L Magnum, after a use, it won´t start again, it cranks like is out of fuel, but after waiting 10 or so minutes,it starts and works like nothing is wrong. I changed the fuel pump and worked normaly for about 6 months and then,the failure it´s back. Note: Some times the engine temperature gauge goes a little farther than the middle mark but engine works fine. It doesn¨t show any engine code besides one oxygen sensor failure.

Went thru 6 starters. Disabled start and shut down while driving. Keeps but keep burning the starters. All sensors/relays are good.

I have a vibration starting around 35 and increases with speed. Not a wheel balance or uneven wear vibration. This is a heavy vibration that shakes the whole truck but not the steering wheel. Thinking maybe a broken belt in the rear tire or drive shaft related. Does have a/t tires installed but no uneven wear. Tpms sensors not reading on both right side wheels makes me believe they might have hit something and damaged a wheel/tire but no visual evidence found. Does not increase with rpm or reduce when coasting. Ive inspected everything visually and all looks good but next step will be to get it rolling in the air to see if anything is out of balance or loose.

Ever since replacing master cylinder, these lights came on, went of after about 100 miles, now back on. All new wheel speed sensors and brakes work fine. Hopefully not the dam dreaded ABS Module.

RPMs below 1, excessive fuel usage

Tries to turn over sounds good but after 2 tries throws code for low voltage oil temp sensor (replaced)
And for crank sensor ( replaced).

Codes p0058, p1775, p0750 transmission going into limp mode. I hooked up my obd 2 and my O2 sensor is working as it should. I even replaced it just to make sure. Thinking it’s electrical but can’t figure it out

I’ve replaced all relays fuses engine coolant sensor coolant temperature sensor and the fan itself it will come on once in a great while when the truck isn’t even warmed up but never to keep it from getting hot

Had all O2 sensors changed out and when it’s plugged in it reads O2 sensor not ready. We have reset the truck by pulling g cables off the battery then driving it for 500-1000 miles and tried to do the constant driving pattern that is mentioned for the test to get the O2 sensors reading and nothing has worked. Could use any other ideas. Thank you

My 2013 Ram lately has been getting bad gas mileage and notice the eco light doesn’t come on any longer. There is check eng light but this is due to ambient temp sensor being out. I was told there may be connection under seat that could be issue. Reconnected every connection under both seats. Need help.

Acceleration suffers at any speed. Hasn't died on me yet but feels like it wants to. Also showing obd code 0443. Fuel pump is fine. (Most)Sensors, spark plugs and timing belt are new. Any ideas?