It cranks but won't start and when engine light comes on I get a no bus code where the odometer is

Abs light on also brake light on plus tach is on 6400 rpms plus running lights and headlights not working at all except turn lites and flashers work. Installed new light switch and checked fuses. Still same problem. Milage is 270,000.

I turned on my truck, and when I got home, I did not want to turn on the dashboard lights, they drop in intensity to the point of turning off, and I get a code 960 and 999. If anyone can help me with that,
And when I try to turn it on, just the lights on the board go out and nothing can be heard for wanting to turn on.

The engine light is showing on the dashboard

my engine got too hot and while it was overheating when I pulled over, it made a loud noise and then stopped when I plugged when I let it pull down and turn it back on now it won’t start. It turned over, but it won’t like there’s no spark to it. I plugged in the obd reader and it said p0601 code PCM issue.

Ok on 01 Dodge Dakota it shut off and no bus appeared in the odometer so I got new ECU and I found melted wires on the transmission plug so I put liquid tape on them let dry I turn the key on I heard very fast clicking so turned key off look around didn't see anything off so I proceeded to turn key back on this time the cluster blow a transistor so I went and go one put it in turn key on everything had power in side light radio,fan but the check engine light didn't come on and it wouldn't turn over like it was before the cluster burned so I checked out side fuse box couldn't find b… Read complete

When riding down the road it starts bucking and searching like it's running out of gas change positioning sensor and still doing it again runs good for a minute and then goes right back to the old way

Hello all, This is my first posting. I hope someone can give me an idea of what to do, or what to replace to fix this thing. Also with all these problems is it safe to drive, or not. I have an 82 yr old mom that is missing doctors' appointments because of this. I have cleaned all accessible grounding points, tie-wrapped down the 3 connectors of the VERY recently installed PCM, I have been trying suggested fixes found on this blog but nothing has worked. Issues became visible when the truck began to stall, at very inopportune times. Crossing intersections, on the freeway, or just idling. BTW, I… Read complete

Starter drags and barely turns motor over. It tuns over like the battery is dead. If I hold the key in the start position it drags on then starts. New starter is acting like the old starter I replaced.

I'm going to get a lot of Mopar people mad but I'm looking for help with a 2004 Dakota that I put a small block chevy in. My issue is the wireharness, I can't find anything that can go from Dakota to old chevy... I'd like to plug into the factory harness to use dodge gauges and key ignition !! HELP

When I start the truck for the first time it runs fine but if I cut off and restart before it completely cools off it idles rough and doesn't want to do over 2000 rpm. When it does this the check engine light blinks and buzzes.