The automatic transmission did not change from second to third gear. I was told it was the camshaft's sensor, it was repaired and worked properly for three months. It has now stopped working completely, all of the gears at the same time. The scanner indicates high pressure and a low in transmission, and the code it provides is p1745,

Motor starts stalling out @ 4000 rpm when accelerating wont shift into High just holds below 4 000

Hey guys, quick question! I have a 2006 dakota Awd 4.7L. The transmission temp light randomly comes and goes. I have no sign of an overheating transmission. It's not discolored. It doesn't smell burnt, not shifting hard or late shifts like it should. If I turn the truck off and turn it back on it usually goes away for a while. Anything I should look at!?

my engine got too hot and while it was overheating when I pulled over, it made a loud noise and then stopped when I plugged when I let it pull down and turn it back on now it won’t start. It turned over, but it won’t like there’s no spark to it. I plugged in the obd reader and it said p0601 code PCM issue.

Transmission not shifting properly

When riding down the road it starts bucking and searching like it's running out of gas change positioning sensor and still doing it again runs good for a minute and then goes right back to the old way

Hello all, This is my first posting. I hope someone can give me an idea of what to do, or what to replace to fix this thing. Also with all these problems is it safe to drive, or not. I have an 82 yr old mom that is missing doctors' appointments because of this. I have cleaned all accessible grounding points, tie-wrapped down the 3 connectors of the VERY recently installed PCM, I have been trying suggested fixes found on this blog but nothing has worked. Issues became visible when the truck began to stall, at very inopportune times. Crossing intersections, on the freeway, or just idling. BTW, I… Read complete

Starter drags and barely turns motor over. It tuns over like the battery is dead. If I hold the key in the start position it drags on then starts. New starter is acting like the old starter I replaced.

I'm going to get a lot of Mopar people mad but I'm looking for help with a 2004 Dakota that I put a small block chevy in. My issue is the wireharness, I can't find anything that can go from Dakota to old chevy... I'd like to plug into the factory harness to use dodge gauges and key ignition !! HELP

When truck sits and idles for while it won't shift from 2nd to 3rd. I have to turn it off and let it sit for while and then it will work again