Gauges problems
Top problems
Starter does not always engage when the key is turned
Chevrolet Camaro 2011 2ss camaro convertible 121000 miles
Starter does not always engage when the key is turned. When it does start it sounds normal.
1 report
KE
Is it possible the starter relay is failing?
Vote helpful
CommentStarter stays in gaged when cranking
Chevrolet Camaro 2012 RS 200000 miles
I have had the starter check and pass when I try to start the car it turns over but when I turn the key back to run the starter stays in gaged I checked the starter relay is good
1 report
Engine failure and fume
Chevrolet Camaro 1995 100000 miles
The engine starts but there is too much fuel moving to the cylinders, and it is fuming way too much, black fume suffocating the engine. I've changed the refrigerant sensor, it worked properly for an hour and the problem returned. I have then installed the original one, it worked fine for a while and failed once more. When it fails, the rpm tachometer drives crazy.
1 report
You need to replace your Camaro's distributor; if it is from the 3rd or 4th generation of this model, it is an agency failure. When you have reached 75000 miles travelled, you will need to change the distributor, and I recommend you a MSD 8381, I now have one of those and it the car is working much better than before.
Check the MAF or MAP sensor, which is in charge of mixing the air with the fuel. When this sensor fails, black fume is released because of the raw fuel.
CommentFuel gauge not responding
Chevrolet Camaro 2012 Coupe 136578 miles
Change the fuel pump out of my 2012 Camaro and now the gas gauge won’t read nothing
1 reply
You need to adjust the float on the pump the gauge works off of it
CommentInfotainment system, all gauges, speedometer,
Chevrolet Camaro 2015 LS3 6.2L 2SS 85567 miles
The stereo system, gas gauge, speedometer, oil pressure, trans temperature, electric gauge, interior screen all went nil at the same time.
1 report
Starter solenoid
Chevrolet Camaro 1987 90000 miles
I have a 1987 Z-28 TPI 350 i put in a 39 Chevy. I have rebuild the engine and it runs great. I have installed a new starter and solenoid ( also i have installed a new 21 fuse wire harness ) but the solenoid spins and won't engage the starter unless you repeatedly try starting it and it eventually cranks the engine and starts. Ive traced back the wires and don't seem to find any issues. I did a voltage test at the solenoid and a got 9v reading. Any trouble shooting tips would be greatly appreciated.
Tach and temp gauge way off
Chevrolet Camaro 1988 IROCZ 160000 miles
At 1000 rpms it goes to over 7000 rpm,
Temp gauge passes the top while driving and sticks. Car also dies when stopping ( possible map sensor bad). Code 34 getting part tomorrow. Checked grounds look good.
Temp gauge passes the top while driving and sticks. Car also dies when stopping ( possible map sensor bad). Code 34 getting part tomorrow. Checked grounds look good.
4 reports
Problems with a Camaro? Share them
Find what you needed?
Thank you!
