Car is stalling and then shuts off, seems likes its gasping for gas check engine light just turned on it aslos says stabili track ans traction control, thehen i took the gas cap off shows signs of water what is the problem

I have a Chevrolet Cruze and I would like to share all its problems: the calipers are distorted which is a really dangerous problem if you do not notice it on time, the automatic transmission locks in 3rd or 5th gears and even the engine stalls when driving.

I smell petrol and water sound under the dashboard

Hello All,

When starting the engine in cold conditions, it vibrates and sometimes stalls. Occasionally, steam comes from the turbo area, which smells like antifreeze. After the engine warms up, it runs smoothly, and no steam appears.
Thank you in advance
Cruze Driver)

Rumble on idle difficulty shifting heavy on gas

I guess it has something to do with the start/stop system cuz when I'm stopped at a red light and I go to push the gas so when it goes to turn on it stalls out so I've been driving in the L gear L6 to be exact... because I find out that's like kind of like a manual it doesn't use the start/stop system so I don't have to sit there at a red light with cars behind me trying to turn my car back on so I can go instead of blocking everyone I hate this car

Hello

I bought a Holden cruze turbo diesel 2012 6 speed manual transmission (same engine as Chevrolet cruze).
My car shakes back and forth between 1500-2000RPM, sometimes late response or no power when I accelerate, or accelerates alone when I use the accelerator. Code 84, DPF, engine lights flashing

Have you ever encountered these problems?

After cleaning the bodywork and car engine and driving for 2 km, the car suddenly stalled. After many attempts of pressing the Start button, it finally did. It then remained off for an hour or so and, when I tried to start the engine again, it did not want to. It was only after the fifth time that it started, worked for no more than 3 km and stalled. Since then it has never started again. I was told the computer is burnt. Has someone got the electrical diagram of the ECM module?

Hi! I have a Chevrolet Cruze J305 Diesel-2013. The car doesn't start at cold weather. I went to a service and they checked the spark plugs and it seem to be fine. They changed the car relay, the temperature sensor, the battery, water pump, the diesel filtre. The problem is still there. Is there anyone who had this problem? What can I do? Thanks.

Vacuum leak, stiff breaks, engine stall, oil leaking in engine

One day it said “service stabilitrak” while I was driving then it dies on me. Now it will crank but won’t start. Had 3 mechanics check it out and apparently they can’t figure out the problem.

My car just stalled out and won't start just clicks once

It just died one day then nothing it drains the batteries. I changed the fuse box and i get nothing before hand not one sound just lights not after changing the fuse box it only cranks no start. Also there's a squeaky sound while the engine cranks could it be a cam sensor or BCM or a timing issue? I need hell getting it to start.

Change oil pan gasket, Put new oil Filter In it and
A peace of rubber got stuck where the filter slides over the shaft.started the car and alot of clincking started.oil presure light came on ,but when given gas it stopped clinking and oil presure light goes off. Next morning started up and ran for a little bit then died. Have not been able to get it started again. Cranks no start. I did not find the rubber piece
Till that morning

My car doesn't want to start it is cranking but not picking up due keylock and code 67, no power on the injectors but fuel is coming to engine, my is a diesel. It s button start keyless.