Ford Ranger Low beam fail

Ask question

Low beam fail

2014 Ford Ranger Dual cab 45000 miles

Low beam on passenger side only has 2 volts running to it. High beam still works

Deon from Australia 9 years ago

Comment

Same issue here

7 reports

Griffo from Australia 9 years ago

Mine too can't find any fuse problems also replaced globe

Vote helpful

Deon from Australia 9 years ago

Have any one had this problem and had it fixed

Vote helpful

Deon from Australia 9 years ago

Had to reset computer. Over load fault on low beam

Vote helpful

Emil from other 5 years ago

Low beam is not working passenger side but the high beam is working perfectly.

Vote helpful

Kuyajac from other 4 years ago

Hi emil may i know how you solve the problem of your ranger ? Thanks

Vote helpful

rosco from Australia 4 years ago

I fitted two supposedly 'compatible' with 2014 PX1 Ranger LED headlamp bulbs and the rh low beam came on then went out, refitted original bulb, no light, the LH low beam also failed a few seconds later. High beam operates however, need BCM reset, not happy I have sent away to a Victorian supplier of a 'specific' Ranger Canbus conversion cable in order to get around flicking a code again, not tried as yet however...
I also have a PJ PK model and there was no problem with similar LED bulbs.

Vote helpful

rosco from Australia 4 years ago

PS Rangers also have to be Canbus modified when fitting trailer brake units, Ford can supply a cable I believe, something also to do with BCM with the brake circuit triggering code when used a trigger for brake controller, can't use rear brake light as trigger ,
I had heard about this but not the headlight difficulty.

Vote helpful