No crank no start, when it does crank won’t turn off, lost all communications with every module, ecu configuration mismatch codes, every fault light will show and the service p brake stays on with stability control and check engine light
Using J-scan and Alpha Obd and then finishing with thinkdiag+ (they all have there strengths and different functions) i had to pretty much clear each dtc from the module. Proxy Align a few times with each of the 3 programs and then recalibrate the eps model. All codes cleared lights off and runs better than ever. It all started with traction control light that I ignored for a while, and then came to fruition after my transmission mount was replaced.
Unfortunately, there is no rear hatch release in the back. I had to resort to finding the wires to the back hatch latch and cut the wires and apply 12v to the wires to open the lid.
I can put the passenger window up on the drivers side but not down and the drivers side won’t work at all. Also the doors will unlock from drivers side but not lock.
Driver s door unlocks and locks but is almost fused shut. Have checked the driver lock fuse and although manuel states it should b. 10, it is intact a 15 but in tact non the less.