I am trying to track down why the battery indicator light either is always on or it is on when you first fire up the truck in the morning and by mid day the light never comes back on. The voltage on the truck says it’s at 12-13 even with the battery light on and to me that seems like an okay operation. I have tracked down just about everything. New battery, replaced the radio, checked fuses and relays. Is there something I am missing???

All the electronics were fine, when I pressed the start button, nothing would happen. After I sat in the truck with the door open I heard it go through its internal checks then I tried starting it again and it worked.

My battery won't stay charged the cable connection was crossed by accident negative connection on positive Post and vice versa it fired the alternator. We then replaced it with new one and the battery won't stay charged in it

Mid hybrid ne h8 battery still wnt hold chage

I tried starting it and it turned over for a second then stopped. I tried pushing start button again and all that happens is the lights come on. I tried the remote start, horn beeps but then nothing. Tested battery it's good. Good connection, no corrosion. Anyone have any ideas?

I’ve even removed the fuse to dash and battery still drain. If lights are turned to auto dash lights won’t dim or turn off, but if only parking lights are on dash will turn off but then how do I get parking lights off?????

When I push the push start the power comes on and I get a click and that is it. It doesn't turn over i have replaced the battery and starter

When I try to crank the truck it will not crank the battery is good and Everything was fine Sunday. But yesterday it wouldn’t start after i replaced my heater core.

The map gps has me somewhere random every time I start the truck. I have tried pulling the battery cable to rest the computer. I have tried a factory reset. Nothing works.

The push button start isn't working, it says that 'trailer brake service' is needed, also a code is flashing for 'four wheel drive needing service', But it won't actually turn over, won't even try and start. I push the brake in, then push the button to start it, and it'll turn the accessories on, I push the button again and it turns it to "run" but it doesn't actually start. The dash just flashes a couple times and then it turns it off.
I'm currently stuck in a parking lot so I'm definitely open to any advice, that being said I've tried...
•changing the brake light switch
•Changing the key fob battery
• doing a "hard reset"(disconnecting the battery for 20 minutes)
•jump starting it
•examine fuses for any obvious damaged ones

Radio sound cutting new battery

I have to charge my battery every week, I only drive 60 km per week

Dash lights stay on when I walk away from the car. I’ve been disconnecting the battery now I’m gonna be putting on a battery Killswitch. I can’t figure out the problem help?

Click during ignition push button start. Vehicle start on second try. Battery test shows it's good.

My remote start does not work on my truck. I replaced the battery in the remote already. Any other suggestions?

The only way to get it off is to disconnect battery. I even unhooked it from the switch and it still stays on

The 2020 Ram 1500 Big Horn is getting error code U0131 Lost Communication with Power Steering Control Module. Fuse 2 (125A) has been checked on the battery, Fuse N7 (80A) has been checked, as well as fuse 35 (10A) Spare 10 Amp Red PCM / ECM / Power Pack Unit (PPU) Motor Generator Unit (M0 ke Up / EPS / Active Tuned Mass Module (ATMM) / ESP. Having a hard time locating the EPS negative bolt behind the passenger headlight.

Over past 8 months my blind spot sensors have not been working. Every time I start up my truck the alert pops up “ blind spot sensor unavailable “ I’ve pulled battery and still have same issue. Anyone experienced this and have a fix?

Had all O2 sensors changed out and when it’s plugged in it reads O2 sensor not ready. We have reset the truck by pulling g cables off the battery then driving it for 500-1000 miles and tried to do the constant driving pattern that is mentioned for the test to get the O2 sensors reading and nothing has worked. Could use any other ideas. Thank you

I had to take the battery off

There's a problem every so often starting the truck with the security system messed up and the key fob is not working I replace the battery in the truck I replaced the battery in the key fob and still nothing can someone help please thank you

Looking for all the ground locations on the truck. No reverse lights, has new bulbs. when connected to trailer lights stay on with truck is turned off. Battery won't hold a charge, battery is brand new. Any suggestions?

The gaskets in the valve cover and the oil filter housing had blew. I replaced the gaskets. Now I’m having problems with the starter solenoid relay which is reading a 2 or higher volts when the truck is turned off. Idk what to do because my pcm is also not getting any power when I use the light tester.