Camshaft problems
Camshaft: It is inside of the cylinder head and it contains the cams. It is controlled by the timing belt.
Read more
More specific problems:
Related problems:
See owner's manual
Top problems
Won't start
2004 Nissan Maxima Maxima 200000 miles
My 2004 Nissian Maxima won't start. It will spin over but it won't crank. Its getting fuel, and fire. Put it on my scanner and its throwing a camshaft postion sensor, and a crank sensor code. ???
CommentChanged the water pump and everything went crazy after
2016 Nissan Maxima Platinum 123000 miles
My car overheated, we changed the thermostat. And the water pump after putting everything back. It wouldn't stay cranked the R. P. M's were all over the place. It was throwing several codes. We replaced the VVT solenoid reset the codes, it ran fine for 30 minutes. Then it started doing it again after we checked the codes, it said that the crankshaft position was over retarded, so I replaced all of the camshaft sensors and it's still not running rot, it's still. Missing and the check engine light and now i'm getting four new codeson please help
1 report
Anti E/Autonomous from United States 6 months ago
What ever came to be with this, did u figure it out man?
CommentP0340 camshaft position sensor a circuit bank 1
2013 Nissan Maxima 190000 miles
I need the location of this sensor
5 reports
Closest to firewall LHS just below the valve cover
CommentCar just turns over a lot before it finally starts then going down the
2002 Nissan Maxima 142000 miles
Have to turn it over a long time to crank it. Can I clean the camshaft position sensor
Problems with a Maxima? Share them
Anyone know about cars? No power to the ignition coils and it won't start. Please DM me if you can help Instagram (hasanzodaymm) my instagram