Noise problems
Top problems
Turn signal doesn’t make sound but light works
Chevrolet Impala 2009 3.5 L 140000 miles
When I turn on my signal it doesn’t make the ticking sound but it actually blinks like it suppose to.
3 reports
AN
Same issue with my Impala as well.
Vote helpful
CommentNoise when pressing gas
Chevrolet Impala 2008 54000 miles
When pressing the gas the car makes a high pitched RC car noise that gets louder the harder you press. There is a subtle, deeper version of that noise while car is idol for a few minutes. The steering and shifting out of park also seem a little rough when car first turns on.
1 report
9 reports
The radio has no sound.
Chevrolet Impala 2017 100000 miles
The radio has no sound. It's just muted on its own. I checked the fuses but they all good.
7 reports
Problems with ABS and control panel
Chevrolet Impala 2001 111732 miles
Hello, I have a 2001 Impala and sometimes, when I turn or when I go over a bumpy road, it makes a "runnn" noise and in the service center it turns on the traction control light and some other times the ABS light. TRAC OFF light stays on in the message center and a sort of radiator indicating the coolant level, and it doesn't go away. If someone has any idea to solve this problem or can recommend a place to take the car to, I'll appreciate it.
3 replies
The problem with the TRAC OFF is caused by the locking hubs of the wheels, and sometimes it causes the ABS issue.
Hello everyone, I have just checked the front wheels of my Impala and I can tell that the wires going to the abs sensor are cut. I have the ABS and TRACTION OFF lights turned on all the time, but I don't think that is new, because part of the wire is missing and those lights were not turned on before. Could it be that maybe they can be disconnected? Thanks for your comments
CommentABS sensor no one can fix
Chevrolet Impala 2014 Ltz limited 175000 miles
My trac control, brake and ABS sensor constant go off, especially when turning or initial acceleration. Now braking makes a grunting noise from engine. Replace wheel hub assembly twice. Was told is the wire from hub to engine but had it "repaired " 5 times! Still won't work...help
4 reports
Mine comes on when the car starts I've tried everything to fix it but those keep popping up on the dash
you need a obd2 scanner that can read each wheel speed sensor and make sure its working correctly
when you change wheel hub assembly please clean that slot where the sensor reads at because any dirt or such will cause innaccurate reading
Abs light is a sensor your hub assembly speed sensor wiring , some come connected to the hub
CommentShaking steering wheel
Chevrolet Impala 2008 V6 200000 miles
When starting the car and right away and turning the steering wheel it feels stiff, and when getting up to speed too fast the steering wheel starts to shake violently. Sound is kinda like a vibrating grinding noise but goes away when turning a good ways to the right.
1 report
Same here, probably a mix of power steering pump and something else
Check tires. This was my exact issue recently, come to find out my front tires were past being bald
Check the hub assembly...the studs too...also aliment does it too
CommentPassenger seat belt problem
Chevrolet Impala 2015 Impala 104000 miles
My seat belt warning sound comes on even when no one’s sitting there it shuts off after you buckle the belt on!!
1 reply
Comment2014 Chevy Impala the shop said it was the fuel pump so I replaced fue
Chevrolet Impala 2014 Impala 150000 miles
What happens is I put a new fuel pump in and I'm still getting no click out of the fuel pump it's not making any noise and I can't find the fuse or the relay for it it's not under the hood and if it is it's late in the right direction
1 reply
CommentSlow acceleration
Chevrolet Impala 2003 Sedan 187500 miles
When at a stop sign sounds like will die out n will slow to accelerate
4 reports
Problems with a Impala? Share them
