I just bought the car from private owner and driving back home, I just noticed that speedo is not working. Do you have any ideas why it is happening? Any fuse provlems? Any wire that is not connected? Plz reply.

I start my car, drive for 2 blocks and it goes into reduced power mode. I changed the negative cable wire, changed the crankshaft position sensor; both camshaft position sensors, and tested the ignition switch, but when the car was off, the dash abd everything would go crazy sometimes abd stay on…. So i tested the brown wire under the ignition and with the car off and keys out there was a voltage reading of about 5 volts…In order to get that voltage to 0, I had to pull this yellow fuse, circled in red, and the 5 volts disappeared

These warning lights came on steering control, power steering, traction control stabilizer and the shifting indicator does not display. It will not shift gears once I start driving and when I do shift from gear to gear it jerks really hard. I notice the bushing on shift cable was broke. So we put a rubber bushing in to see if that would work. And it started working but once we put the rite bushing on it stopped working and now matter what we try it will not work. Disconnected the tcm and the ground tested hot. Look over the ground wire and it's not showing any damage to it. All fuses are good also.

I have a 2014 Chevrolet Cruze 1.8 (VIN: 1G1PA5SH9E7449244) with automatic transmission. The original engine was replaced with an F18D4 engine, but the ECU is still the original LUW type. Problem: The engine has unstable idle, especially in Drive (D) at low throttle. RPM fluctuates and there is slight vibration. Scanner readings: - Intake camshaft position: around 44° - Exhaust camshaft position: 0° at idle - When pressing accelerator slightly (about 10%), exhaust camshaft follows intake (around 45° intake / 48° exhaust) Tests performed: - Disconnecting intake VVT solenoid improves idle sig… Read complete

I have a cooling fan will not turn on at any temperature I ran a scan have a p0480 and a p0691 code I believe it is a connection problem under the fuse box with a terminal being loose my problem is I pulled the wires out from the connector and by dumb thinking I didn't take a picture or record the port number I was trying to see if anybody could give me the info fryer green wire black and white wire in the X1 location under fuse box that would control I believe a relay for the cooling fan motor or ECT

My cruze 2011 won't crank or start.Only cranks if I bypass with a piece of wire put on starter selinod where silenoid goes.

The passenger side, (right rear), tail light has an issue causing a malfunction. If constant power is off, (lights off), then everything works. Brake light works, turn indicator works, hazard flashers work. Everything is fine until the lights come on either automatically or manually. When this happens that one light only fails to function. The tail light is on and working but none of the functions I mentioned earlier work. Not one single function, but only with that right side rear tail light. So what would cause this? Could it be a problem with the BCM? All of the bcm fuses have been checked… Read complete