I have an intermittent inop condition with only the "auto down" feature of the driver's window. It works to lower and raise the glass by holding the switch just fine. Is there a calibration procedure?
If the battery dies and the computers are reset, you have to recalibrate the auto down/up feature for all windows. Just hold the window switch down until the window rolls all the way down, and keep holding the switch down for about 3 seconds. Then roll the window up with the switch and hold the switch in the up position after the window closes for about another 3 seconds. Your auto up/down feature should work now. Repeat for all windows.
Ive sorta got the same problem but already programed, and down works fine, but not up, if i hold then it goes up, but the auto is inop. Im thinking its the actual switch , feels like there is 4 steps to it, auto down-man down-man up-auto up.
That worked. If it isn't the switch that's failed, then it sort of acts like a computer reset - disconnect power for a bit, reconnect, and it works again. Go figure!
Driver switch window not working but the three switch are working. I try to replace the driver side switch still the same only the driver window is not working it motor, wirings or fuse?
Changed out battery and now windows, locking system, horn, windshield wipers and trunk won’t open. Yes I used a memory savor. 3 rd time switching out battery. I can’t seem to find the blown fuse.