The car starts but idles rough. After driving it a few feet the accelerator will stop working. Shows engine codes for a cylinder 2 misfire and a MAF issue. Have tried changing spark plugs, coils, sensors and gaskets and nothing seems to resolve the issue.

The car doesn't have a launch control feature; I tried pressing the brake and accelerator simultaneously a few times, and afterwards, it started leaking oil from the area where the transmission connects to the engine—though it doesn't leak when the car is turned off.

Car functions normally but sometimes, mainlly when ambient temperature is hot it has problem to start, it will crank, but I have to press gas pedal and maintain higher RPM for a while for it to not stall and shut off, after a few seconds depress the gas pedal and it will work normally

EPC cans on car shuts off after about 20 minutes of driving it. I haven’t driven the car in about two years now trying to pretty much sell it for scraps because I don’t know what to do with it can’t afford to get it worked on. Had somebody do a diagnostic with a Mitchell one program they came to the conclusion that was the alternator. I replaced the battery about six months ago in the car. Will turn over now, but still has a few lights on the dash in my throttlebody position center and pedal codes are popping up on my diagnostic code reader

Car will not move but revs when in drive or in tiptronic shifting. The speedometer shows the gear display and what gear you are in right, but now each gear is highlighted in a solid red square. Was always just the letter or number. At first I would shut it off and let it sit a minute and restart it and it's good but now it's just stuck like that

Jetta 5 VI 1.6
Engine: CAY303831
Vin: wvwzzz1kzam166702
Model: 2011 I start my car and I press accelerator but the rev counter stuck between 2 and 3 and there is no power at all so what does it mean and how to fix this issue

My car have no power and once I press accelerator pedal the rev counter is between 2 and 3 not moving up to 5 and 6 why? Please help me to solve the problem

Check engine light is on i range the code it says map sensor and throttle body how do I fix this

My Jetta 3 CLI 2.0 it revs up and down between 10 and 20 and over revs when changing gears. I have changed, idle valve, distributor, Coil pack, clutch kit, cleaned throttle body, changed oil, but the idling is not stable

My vehicle gives this error code