GMC Canyon problems and issues

The ac won’t get cold if it’s over 100 degrees outside

2017 gmc canyon code b1517-5a

Upon acceleration, there is a high pitch whining/grinding noise. When you release the gas peddle, the noise almost stops. Also makes that noise when turning around corners. There is also a very noticeable vibration around 35 mph.

Airbag system light is displayed on dash

Heat or A/C fan only works on high. I’ve replaced the fan switch and it worked for a while but now I have the same problem.

When I start the truck, with "auto" selected, the headlights don't always come on. Is this a fuse issue?

Transmission slips & shutters on take off

Mi blower no enciende tiene Conectores nuevos y blower nuevo y resistencia nueva y no prende no se si le llegara corriente o no en el control climático ninguno de las velocidades lo enciende

Air bag warning light on dash remains on

No power in ignation switch
2010

Throttle body has low voltage and cranks over but will not start

I dont have any parking lights up front or in rear and my brake lights dont work but I have rear blinkers but not front blinkers

Alarm keep going off! I want to disable it?

My third brake light doesn’t work the cab lights work, but not the third brake light

My ac not working
And need to get a new k1 fuse to replace.

Went I turn the ignition on; I notices the daylight on the dashboard are off. It does various time during the week.

Detecte que en cada cambio de velocidad tiene unos jalones,

Replace trodlle body sensor and pedal and only trodled up once in park

I give it gas and it does not do anything and it does start and idle fine but when you press the gas pedal there is no response the truck will not accelerate

White smoke coming out exhaust
On and off

Where do I find the fuse for city light? I read the manual, and I only can see the headlight high Beam. Any help? Thanks

No speedo, tack, fuel gage or mileage

Window driver side not working and lock doors bottom too , this thing started when I used jump cables

Any recalls on 2020 GMC canyon radios? Su ofre are a lot of trouble posts.

Have problem with po335 code crankshaft position sensor circuit, already replace sensor ,checked the wiring from sensor to the ecm ,replaced ecm and the code trigger soonest I open ignition switch

Radio lost communication and no screen picture some lines, infotainment system restarts every few minutes trying to reestablish connection. Drains battery with 2.4-3.5 A current, even when the ignition key is out.

Fan keeps running temperature drops and engine light comes on

Fuel Gague has stopped working.

2020 gmc canyon my rear running lights are not working break and turn signals work but running lights are not