Transmission problems

Transmission: It is the place where the different "gears" of the cars are located.
Read more
More specific problems:
Related problems:

Top problems

Transmission

2015 Chrysler 200 2.4 150000 miles
Gear stuck on the 4 gear and has code p1da9
Jayh021968 from United States 4 months ago  
JA
1 report 

Transmission shif won't go in gear

2016 Chrysler 200 160000 miles
Won't start and all the lights are flashing on the gear nopd
Chuck from United States a year ago  
CH
3 reports 

New screen chrysler 2015

2015 Chrysler 200 156000 miles
The idea is that I installed a new screen from a 2016 model into my 2015 car, and because of this change, the front speakers no longer work. However, when I switch back to the old radio, all the speakers function fine
Brahim from United States 8 months ago  
BR
1 reply 
dcwilliams8118 from United States 8 months ago
You need to go to the dealer to get it proxy flashed. The radio you put in is set up for the Premium Sound with amplifier. Just did this last week myself
Comment

Transmission

2016 Chrysler 200 176000 miles
Gets stuck in high gears when driving slow. Will completely not drive once you stop when this problem is going on. Example: my car was stuck in 5th doing 50, stopped at a red light and it wouldn’t move. Pedal to the floor and would only make a slight rev noise. When it’s acting like this it also won’t go into park. It’s been doing this more frequently lately but it does come and go. A few things to note I keep the car up to date with everything, oil, transmission fluid, everything. I also took it to a Chrysler dealership where they stated they replaced a computer but then admitted to joy riding the gas out of my car and couldn’t get it to act up.
Heatho from United States 2 years ago  
HE
4 reports 
Brayan from United States 7 months ago
My car does the same thing on the highway every time I hit the gas pedal and hit 3000 rpm from gear 9 goes dow to 7 and I don't know what to do already took it to the shop and they didn't figure out the car don't show a engine light on dash I wondering what y'all recommend me to do
Comment

No start no crank with all PRNDL led lit

2015 Chrysler 200 Sedan 2.4 liter 141500 miles
No crank No start i hear the fuel pump prime and all the accessories work fine. Also more concerning the message states "transmission issues get service" and "car must be in Park to start" and will not allow me to turn off unless I pull battery terminal. ABS CHECK ENGINE LIGHTS are on and numerous codes U codes pop up. U0101 code i see the most even when clear code. Along with everything above the trunk button fron fob and interior does not work unless I disconnect and reconnect battery. If I kept the car siting then mysteriously come back to the state where I can start it fine and it drives b… Read complete
Krod93999 from United States 9 months ago  
KR
2 reports 

Throttle light and traction light turn on car will not shift

2012 Chrysler 200 2.4l 171000 miles
Throttle light and traction light turn on car will not shift
Car doctor from United States 2 years ago  
CA
8 reports 

Brake Pulsation

2014 Chrysler 200 Touring 3.6L V6 175000 miles
Whenever I start the car, the brake pedal pulsates until I drive about a hundred feet or so and then my abs and my traction control lights come on, and the brakes go all the way to the floor after it stops pulsating. I also cannot bleed two out of the four brakes. Not sure if this is a common problem, but I've seen people that share the same issue when I did my research.
Lexie from United States 3 years ago  
LE
5 reports 

Clicking noise

2011 Chrysler 200 6ccy 177000 miles
Fuse box clicking noise tcm low power
Don't Understand from United States 3 years ago  
DO
11 reports 
Problems with a 200? Share them
Submit commentCancel
Submit replyCancel


Find what you needed?

Thank you!