Need diagram for trunk latch and button to determine if the button/latch is bad or if its the module.

The fuse box in the owners manual does not correlate to the actual fuse box in my car, also where can I find a wiring diagram

Good morning all. My car is a Fiesta power 2005 and, for 6 months now, it has been presenting a huge failure, that started by appearing occasionally but is now quite frequent. It seems to be a spark plugs' failure but it is not. When starting the engine there is no problem, but after a while, the car starts failing, it loses power, chokes and I need to accelerate it so that it sets out and be careful because it suddenly speeds up. The engine trembles terribly and, if the air conditioning is turned on, it is even worse because it is ever more powerless and almost stalls, even though this has ne… Leggi completo

Phase circuit faults a and b clutch actuators. My snap on says short to ground on an and b actuators. Unsure of issue. Replaced a TCM the TCM wiring harness the clutch actuators A and b all fuses in the cabin and under the hood have been changed. PCM‘s been changed still has the same same problem P707 2802 any help is welcome

I changed my fiesta mk5 1.8di engine with the same engine due to the cambelt tensioner failing wired it all up it turns over but no start up really need someones help

I’ve replaced everything that it could be I’ve looked at wires and nothing seems to be broken I just can’t figure it out can anyone help me???

Code: U0151 - Lost Communication With Restraints Control Module

Status (-2F):

DTC Present at Time of Request

Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Panel Control Module

Can anybody help with this?

Car wont start. Only turns over / cranks.
Does anyone have wiring diagrams for RCM so I can test between RCM and instrument cluster?

Hello, car had used engine installed that had 15,000 miles. Only problem that returns is a misfire when accelerating to pass someone or when getting to highway speed it shutters and loses minor power as well as flashing check engine light. Codes read misfire for cylinder 1,2,3 but sometimes only 1 and 2.
Installed new OEM sparkplugs, coil pack, and coil wires.
Car works perfectly besides the random misfire.

I recently took the engine out to skimmed the block, as I had a water leak from piston 3 into 4.
I put it all together again, but couldn't find the plug for the back of the engine from the wire harness.

I do think this is the cause of my problem due to having everything else back in place and timing checked.
Could anybody please advise me onto where this plug may be. Many thanks.

Had a problem with the speedometer lately which thankfully I could fix, but whenever it's dark my headlights, taillights, stereo / heater, etc. all light up. Everything except for the Speedo, rev counter, fuel and temp guages, and the center screen.
My guess was faulty wiring but I looked at it and determined the wiring was all still fine.
Right now I'm guessing it's bad contact but a new dash would cost me way too much, seeing as I'm driving a 20 year old shitbox and would have to go to a Ford garage, pray they have a whole new dash, register the new dash, etc.

Any way to fix a bad contact that isn't just hitting it til it works for a day or contact spray?