I lost brake and turn signal lights in the back. I have running lights and the brake light on the back of the cab works. Fuses good. Can’t find any apparent breaks or rubs in the wiring. I’m stumped...

The brake light stays on. Why would this be happening?

Thank
David

The brake lights don't come on when I push on the brakes, the horn does not work and the shifter does not want to shift from part. Has anyone had this issue before?
Thanks in advance

My hazard, turn signal, and brake lights aren't working

Replaced fuse location 42. Still no signal.

I replace the bulbs I have checked all the fuses I replaced the flashers and I still don't have turn signals brake lights or hazards

Trailer running lights are out but brake and turn signals work

Power windows would not work after having truck parked for sometime. When i first got it tuned up to get back on the road i noticed power windows didnt work. After checking and changing and adding missing fuses, the power windows worked but the night time running tail lights didn't work. Didnt notice at 1st bc it was daytime. But 1st night drive i found out later than one would like. So turn signals, hazards, brake lights, and reverse lights all work. But not the tail lights. There isnt any fuse directly labeled for this in the cab fuse box or the one under the hood. Anyone know what fuse controls these or could cause these to stop suddenly along with the dash cluster back light illumination stop work after the the first fuse fix to correct the power windows.

My left light isn’t working. Right side does

My brake lights and shifting from park to drive does not work

Brake lights not working. Fuse is good

When I'm driving at around over 40mph and I brake quickly, the truck feels as if the brake gets stuck and it moves slow as if I'm stepping on the brake. I have to wait for almost a minute for it to responde again, or put it in parking and change gears for it to move.

Battery corrosion is very bad

No left turn signal nor brake light work also the third one on cab ch fuses,wiring has no signal only ground and tail light. Also the front one does work just not the back one. 2012 f150 ext cab non 4x4 with a 3.5L engine

Driver side brake light won't work or the turn signal

Brake lights do not work, (third above the window does work), Turn signals work and running lights do as well.

Since the third light works I assumed it was not the switch... I checked all fuses and they were all good. I changed all bulbs, just to check and the same results.

Any ideas?

Tail/brake lights work.no cargo/3brake/interior lights. Dashpanel lights works.no lights on air conditions controls

Back brakes work front do not

Truck loses power intermittently when going slowly up a steep incline, lunging and surging

Also parking brake light will not go off, and cruise control stopped working because it thinks the parking brake is set

Try to start the truck this morning. Pressed on the brake brake pushes back up. Truck won't start. What the hell do I do? Plenty of break fluid in reservoir.

Brakes go all the way in and I change the brake boost and cylinder too

My brakes feel like they are sticking and it loses power when I push the gas petal

E brake won’t release- trying to check the fuse but I can’t find a diagram that matches the fuse box

Brake warning lite randomly

My truck starts without me having to step on the brakes. Because of that, I cannot just put it on without starting it. I read that the pedal positioning sensor can be faulty. What can I do?

My turn signals work, but my brake lights don't. I put a new brake switch, but s till no lights

Tail lights not working brake lights not working how do I fix this

Both rear brake lights are not working. Third brake light is. All fuses are good. Replace brake light switch and the multi function switch all other functions of the rear lights work

Light bulbs are good, which fuse is it