Dash lights are dim all the time when lights are on.
Control does not dim or brighten lights

Doesn't start when turning key to forward position

This just recently started happening. When I start the truck I hear a loud popping noise which seems to be coming from my dashboard screen. The first time it happened it really caught me off guard and then my truck almost didn't start so I thought it was a battery issue, but now the truck starts just fine. Please advise

I have the SERV TPM sensors light on

I took it to the tire shop and they said they are not able to fix it.

They put new TPM sensors on all the tires and reset the computer.

Would like to know what i can do to fix the problem.

Occasionally, my car does not start and the battery is ok. When it does, a padlock signal blinks in the dashboard and I need to wait for around 15-25 minutes and then it suddenly starts working. How can I unlock it?

When driving normally, suddenly the dashboard turns off, being the padlock simbol and the Check engine the only things that remain on. And still, they won't even disappear when turning the vehicle off. What is more, when trying to start the engine again, I usually need to wait between 15-60 minutes and the dashboard failure keeps appearing. I wanted to know if someone had this inconvenient and would like to share a solution. Thank you.

Had a bad jump start that fried a few things a few months ago. Replaced battery and alternator, so those are both new, and replaced the 100 amp mega fuse and A/C relays. The truck started and ran for several weeks, but then one day turned the key and it did absolutely nothing...also, absolutely NO lights on the dash display except for the check engine light. Had a friend test with scanner and it can't link with computer. Got a new programmed PCM, installed it, and same problem. I think it's a relay, but no idea which one.
Also, we've noticed that now the brand new battery goes dead quickly, like, in about 3 weeks. I just think that's awfully quick for a new battery to go totally dead. It's as if something is stuck ON and draining it. Any help would be greatly appreciated!

My van loses power and the Power reduced message appears on the dashboard.

Después de un rato de manejarlo pierde fuerza le aceleras y no responde y petardea y lo raro q no se le prende el aviso de check engine
Después de un rato de falla se le quita y luego vuelve y así mientras está en funcionamiento

Every morning after about 5 to 7 min the ABS, Traction Control and Brake light warning turns on and the messages Traction Control Fault, ABS fault and brake fault shows up. 4x4 is allow but on 4x4 Lo no dash indicator. At scan tool under Cruse control and / traction control under the engine module I can se TCS short to grown/open hight

Service airbag light comes on everytime I start the vehicle any ideas took to the shop and can’t find the problem

Often when the truck is first warming up but occasionally when I've been driving for a while, the front end will make a noise like a creak you hear while walking up a set of old barn stairs as I crank the wheels to turn the truck. It is more likely to happen when I make a tighter turn. Is there something that needs to be greased or is it just a sound from something flexing oddly?

An alert has popped up on my dash saying "Service 4wd" the 4wd will not engage and there are no leads as to what this issue could be stemming from. Any help would be great Thanks.

Did an update two times in a week through wifi and it completed. However, after updating every once in a while after my tuck sits at work for 12 hours, I'll get a message when I crank it up saying "Power Steering disabled" "drive with care" I don't know what it could be. Took it to dealership to check for codes because 1 time the check engine light came on. They said it was in the history and it could be something electrical. Im lost...
Help

Engine will not turn over and Engine locked light is on

Mechanic changed oil in my truck and afterwards an engine light was triggered that said 200amp blown alternator fuse. Mechanic tried to order and it is on back order with unknown eta. So now what can I do?

Communication errors, U0073, U0101, P0700 plus three other codes. All the dash warning lights go on, once the vehicle gets warmer, shut it off and turn it back on, only service engine light is on, won't shift. Clear/erase the codes, no service engine light on, shifts fine. Put in new battery. The ABS fuse was replaced earlier

Get message low oil. Oil ok oil pressure ok

Electronic power steering displays then dash gauges go crazy and trans is hard shifting

My auxiliary switch, which is on the dash, I had hooked up exterior lights to that switch. They work just fine, and then they didn't. Now i've checked the power, and everything is correct from light back to the switch. When I checked to see if there was any power coming from the switch when I turn it on there is no power.I'm not getting any power whatsoever. I checked all the fuses inside the cab near to where it wires up and everything right. Is good? I am now at a loss.Can you help me find out why that switch?Does not have power any longer? The switch does still light up on the -, but the switch is not letting any power out. Any help would be greatly appreciated. Thank you.

My check engine light plus a Starlite message appears

Dash lite says gas cap problem
Take cap off put back on!
Problem gone, till the next day,
Gas cap looks ok!
Is it a air leak inside cap?

Changed gas cap, in 2012, still have gas cap issue on readout on dash,
If I stop truck, shut off engine, take gas cap off, replace cap. Restart engine, light goes out
On dash. Every time I drive it. Am I getting a vacumn leak in tank. ?

When driving,I accelerated and an obvious hissing noise started under engine/transmission.no power loss,no warning lights,no shifting problems. I went under truck,but could not pinpoint the source of the hissing. Any ideas?