Wiring problems

Top problems

Seat belt wiring

2018 Volkswagen Vento sedan 57000 miles
In my vw vento 2018 there is no seat belt warning. No wires in bukles, how to wire them and where.
shubham from India a year ago  
SH
1 report 

High fuel consumption SolvedSolved

1997 Volkswagen Vento 180000 miles
Buddies, please help me. My vehicle has got an extremely high fuel consumption, around 4 km per liter. It was scanned but no error was indicated. The failure appeared after I replaced the cylinder head gasket. What might have happened? I've already changed spark plugs, wires and even the rotor, but nothing got better.
joyce from United States 11 years ago  
JO
2 reports 
mervyn from United States 11 years ago
Hi, joyce, by your diagnosis, it might be a low quality fuel problem. If it is so, use up what you've got and fuel the car with vi power diesel or premium diesel. Another possibility is that there is an electronic problem and you need to make an electric check: flowmeter or EGR valve. Hope it helps.
priscilla from United States 11 years ago
Try changing the oxygen sensor and your problem should be solved.
Saran from India 4 years ago
Vento 2014 model oil mixed my coolant tank what can we do?
Gonza R from Argentina 4 years ago
Typically, it would be due to a damage of the head gasket. For Diesel models, it could happen due to a seal failure in the oil cooler.
Comment

Coil light blinks and car stops suddenly

2012 Volkswagen Vento Sedan 1.6 TDI 105000 miles
After driving above 80-90kmph my car suddenly stops and coil light start blinking. After switching key off and on again car start and light goes away. Checked and cleaned injectors they are okk. Wiring and connectors are ok. Scanning shoes fault code" P2147 Fuel Injector Group A Circuit Low " shows.
Mahesh from India 3 years ago  
MA
15 reports 
Vicky from India 3 years ago
Same here but not injector problem it showing crank & camshaft sensor problem
Renato from other 3 years ago
Bom dia, meu carro liga normal mas desliga, modelo Virtus
Abi333 from India 2 years ago
I have experienced this on my Vento TDI 2012- Please take a look at the MAF (Mass air flow sensor) - Might be a sensor issue or the wire's are loose also another chance might be water in the diesel tank , Try with new diesel filter - (if the coil shows up after a fuel refill it must be with fuel an injector cleaner can fix the issue better try with a new diesel filter ) - These checks resolved my issue -
Tdi2k14 from India 2 years ago
Same issue with my car,
Vento TDI 2014
Clicking noise from fuse box and intermittent electrical missing which would end up in coil light blinking and low pickup. Restarting would solve the issue.

There was no MAF sensor problem before. Now the blinking coil light is permanent and MAF sensor circuit high is showing. The missing has increased a lot now and its happening after 5-6 kms of a cold start
Evandro from other a year ago
Virtus 2020.
Simbolo da injeção acendeu. Mas o carro continua normal. O que será?
Jafson from other a year ago
O carro está fazendo um barulho estranho quando acelera mais forte, como se tivesse algo folgado
Comment

Run out of battery

2009 Volkswagen Vento 84000 miles
Hi, I have a Vento and it run out of battery in the garage. What can I do? I was told that something might break down when connecting it with wires to another car. If I want to start the engine, can it be pushed? What is the most convenient thing to do in this case? Thanks.
Vina from United States 11 years ago  
VI
2 replies 
Dunk from United States 11 years ago
Hello, you can give electricity with another car, nothing will happen. You simply need to be careful and keep the key on the turned off position on both cars when the wires are connected. The RED wire goes in the positive terminals of both cars and the BLACK wire goes in the negative terminals. After connecting them, start the car that has the charged battery, wait until the idle speed stabilizes and then start the other car. Once it started, remove one by one the wires and pay attention that the terminals do not make contact or touch the bodywork. Maintain the vehicle which had the failure turned on for around 20 minutes, until it recovers. Do this with the lights turned off. Hope it helps you.
Dunk from United States 11 years ago
If there is not enough space for two cars, you need a charged battery. You then connect the wires as mentioned before and activate the key to start the car.
Comment

Display turns on and off

2006 Volkswagen Vento 87000 miles
Hi, I hope you can help me. The display on the middle of the dashboard turns off and on every now and then, as if there was a loose wire or something like that. I have no idea which are the wires that need to be checked.
mena from United States 11 years ago  
ME
2 reports 
mena from United States 11 years ago
I wanted to share that I was finally told that the display was damaged and that was the reason why it worked intermittently. I had to buy an old-line dashboard, remove the one I had and install the one I bought. It was necessary to reprogramme the dashboard with the memory and other stuff it brings. The other option I had was taking out the display from the bought dashboard and install it, but it was quite risky the manipulation of the fragile elements. Hope my experience helps someone else in the future.
Comment

When I switch on the key, fuel tank pump was not working

2008 Volkswagen Vento 200000 miles
I have checked the motor it was good,and also checked the wiring from the relay to motor it was also good
Kindly help me to identify the problem.
Yogesh from India 4 years ago  
YO
7 reports 
Problems with a Vento? Share them
Submit commentCancel
Submit replyCancel