After fitting New RR Brake calliper I have not been able to get brakes bled properly. We tried putting 20psi air pressure into the fluid reservoir, we have followed the Toyota brake bleeding process perfectly. Also followed all advice on IH8MUD re brake problem. The ABS Unit has never worked on this vehicle since purchase, however we have changed out 2 other brake callipers and 1 burst brake line, with no brake bleeding problems. This time is very different. Brake pedal going straight to the floor. During many brake bleeding attempts we believe that air may have gotten into the fluid reservoir by mistake. Any help or guidance will be gratefully received.
الموتر نظيبف والامور طيبه فجاءة وانا رايح اعبي بترول كان الخزان الكبير فاضي والخزان الصغير في الربع المهم قلت له صب سوبر فل بداء بالصغير فوله وراح حق الكبير ضغط عىشان يعبي يفصل الجهاز حق البترول ويقولي الخزان فل وانا عارف ان فاضي حاولت وغيرت الطريقه في التعبئة نفس الشي يفصل / هل هو الحساس والا فيول والا ايش اللي عة خب ه يعلمني
When I drive for 4 hours the gas pedal begins to not respond when I press down it jerks me shaking the car a lot all the time when the car gets hot and the rpm’s jump to 2 and back to 1500 repeatedly making a sound whining up and down
Have you checked your transmission fluid? Verify the level and condition while the engine is warm. If the fluid is dark, burnt, or low, this is likely your transmission overheating. Also go to a mechanic to have them check for a failing throttle position sensor
Car shaking/ vibrations sometimes in speed limit 50 to 60 km/h and 60 to 70 km/h
In rpm higher than 1.2 x1000r/min
Sometimes Harder vibration in slower drive while rpm higher than 1.2 x1000r/min
Sometimes Lower vibration in fast drive while rpm higher than 1.4 x1000r/min