The fuse diagrams do not show any dpf fuses. Does anyone have a diesel diagram for fuses?

Need location of fan control fuse on IPDM

My heater won’t blow heat out and it’s nothing but cold air. I already replaced the heater control valve and still nothing. What fuse do I look for or what else can I do to make this issue stop?

I believe I had a short that blew the fuse. Where is the fuse for the back up lights?

I have changed changed crankshaft sensor. Have checked all fuses changed fuel pump cleaned charcoal canister and furge valve but still
L won't turn over

Been trying to trpuble shoot the ac last few days. Nothing apprear to be worng... compressor good. Fuses...good... trst shoes refridgersnt is high in theee... what gives?? It was working 2 weeks ago

? And today as I drive it to store it accelerated above. Normal speed...without hitting the pedal it was coasting about 45kms.. . As I drove it I noticed it was lagoon n bogging out around the 40-65 kms.. . Put it in manual on way home to find out as it was on 1st it jumped to 3rd. No warning or no faults showed up on testing it. But now it has engine light so will test again...
Gonna be easy fix or. Costly?? :( horrible timing for this
Anyways. That's what I can. Thonk of so far...

I can't find a service manual for my Titan SE 5.6 v8 and the fuse and relay diagrams don't match. My back fuse box under hood is black and has a "N" on it. And front relay box only has 4 relay and my covers don't fit the diagrams either.

My truck has two diagnostic codes that come up when checked P0447 P26E4. The code P26E4 is the starter relay which I can't find that relay in the fuse box. At low speeds it wants to jerk like its not getting enough gas and it starts to shake.

Hi everyone After doing a bunch of work on my truck, alternator, exhaust manifold, front struts,mafs sensor,tuneup, and repaired some broken wires for my fog lights. Truck ran great but my dash lights were still coming on or there would be no dash lights but it would go into slip mode and lose power. Turn off VDC and truck runs no problem but eventually the other lights would come back on, abs, slip. And vdc. Anyways long story short I had a head light out so I went to replace it. I still havent replaced my inner fenders so i sstarted the truck up and cranked the wheel to the right all the wa… Read complete

So I have a check engine light on. When I hook up my diagnostic tool it tells me grille shutter not working. I have already check to make sure there is nothing blocking it from opening and closing. My question is there a fuse for this that could have blown?