Dashboard problems

Top problems

The coolant gauge

2008 Mercury Mountaineer Awd 159000 miles
The coolant gauge fluxuates from normal to hot while driving to
Kerry from United States 5 months ago  
KE

Parking light/ turn signal replacement

2004 Mercury Mountaineer 4 door, 4.6l, hatchback 234000 miles
After I replaced the front rt park light because it was out, i replace light then i have the dash indicater light came on like it was out or going out, so i take the encasement out and it comes on again. I put it back in it stays on until i use my brights or turn signal. Note, the daylight running lights did work and fog light used to work too. It didnt work next time and i lifted the bundle of wires from the light and it clicked on again. I looked for a bare wire from the exposed bundle so i taped it hoping that would keep it on but it did not. Could this be a interior light switch replacement issue or a wiring issue?
Angie from United States 9 months ago  
AN

Fuel gage not working

2005 Mercury Mountaineer 200 miles
Fuel gage not showing amount of gas in tank
Cindy from United States a year ago  
CI
4 reports 

Engine cuts off idles rough cuts off won’t start acat different times

2007 Mercury Mountaineer Sub 4.6 v8 210000 miles
Engine idles rough cuts off wheel driving or won’t start at random times Needs jumped will do it while riding all dash lights come on than everything off even headlights before it dies than doesn’t have any power when it goes at first and other times it’s fine any ideas new barrier and alternator 2 times
Mercury 2007 4.6 from United States 2 years ago  
ME
4 reports 

Electrical: ECM is going out.

2010 Mercury Mountaineer Premiere, 4.0L 2-wheel drive 160000 miles
Probable ECM failure
OBD Codes; P2112, P2104, P0403, P0443, P0053, P0054, P0059, P0060.
Some sensors will need replacing, Some Wiring needs repair.
Wayne D from United States 2 years ago  
WA
3 reports 

Won't start

2001 Mercury Mountaineer Base 5.0 liter engine awd 17295 miles
After replacing the lock cylinder and having a brand new key made and programmed everything comes on it's working right now it laying all that stuff but it won't start now and it was sitting for maybe a month and a half now there's a shot that looks like a relay on the fender like most Fords an old big one and I took a couple of wires off of that that didn't look like they were attached too much of anything I can't remember being on anything and maybe the problem but I'd like to hear from some new people out there maybe you got a better idea on what maybe is happening here thank you for your time if you will get a chance to drop me a line thank you bye
Will from United States 3 years ago  
WI
2 reports 
Problems with a Mountaineer? Share them
Submit commentCancel
Submit replyCancel


Find what you needed?

Thank you!