Transmission: It is the place where the different "gears" of the cars are located.
Read more
There is a shaft that comes from the engine and then there is another one that comes out of it and goes to the wheels. Through a set of gears, it moves at different speeds even when the engine moves at just one constant speed, so it takes advantage of the engine's power. They may be manual or automatic.
03 dodge ram 1500 5.7. L just bought it... haven't ran in five years... bought new fuelpump dump old gas out. Put new gas in. Change out starter... crank it over no start. Check fuel rail getting plenty of gas... but doesn't start. So I spray startingfuild an it started real fast. That I know there problem is I. The fuel system... I put the testlight on the injectors I'm getting my 12v. But I am not getting the single. This is where I need some advice... Ty
I was moving into a new place parked it in the laneway and when I came back out in the next morning I no longer had power on the electric shifter, I ordered a used shifter that supposed to work and I do not have power on it.
I've checked fuse 94 and its fine what else should I check.
My Dodge Ram was acting funny. When I woke up it was dead so I had to jump it. That had never happened. Then my door locks didn't work plus the alarm wasn't working. It all started when the raido quit. So nothing was working right. I ordered a new raido on line and it wasn't a replacement it was a JVC with an amp built in. I forgot to mention I had to take the fuse out to the raido while I waited for the raido to get here. Anyway I ordered a wiring harness for my Ram and installed it then put the fuse back in and everything has been working fine for months until the AC issue I'm having now.
Hope it helps.
Truck won't shift out of gear and started in but when it's off you can shift through all the gears I took off the pressure plate and the pilot bearing fell right out what could be the problem It didnt mess up when I was driving it. It was the next day I went to start it and it wouldnt shift out of the gear it was started in.
Put the shifter into neutral and start the truck. While it is running see if you can put it into gear while pushing the clutch pedal. If you can't then your clutch isn't releasing. Isn't that a hydraulic clutch? Make sure it is full of fluid and pump the clutch several times. If it is low, you have a leak but sometimes you can pump it enough to get it to release.
I've already replaced the sensor and it runs fine except ever once in a while it throws the code again and runs like crap causing multiple misfires, stalls, won't shift into 5th gear. Then after a few days it goes away and everything is fine again. Wtf????
The steering on my truck is very hard to turn...I tried adding power steering fluid and realized it's electric and doesn't use fluid... please help I'm totally confused because now there's a dinging noise like seatbelt not on or door isn't closed right. The dashboard lights start going weird then turn off. Next morning battery dead I boost it and I can't shift gears. Turn it off then try start it again it's dead for a minute so wiggle key around a bit and it turns and I can shift gears again. Last but not least I get to my destination I park turn the key off and truck is still idling??? I take battery cables off both sides and still idling??? I have to take a fuse out just to turn the truck off. Can all these problems be fixed?