When I start the truck it’s fine until check engine light come on and if I give it gas it stalls but if I burly give it gas it’s fine and I change fuel pump, filter, injectors,throttle body, más air flow sensor, tps , and I don’t know what to do I think it’s my speed sensor that come out my dash but I don’t know

My Tacoma indicates codes p0325 and p0336 and it loses power when starting and after a while, it suddenly develops. I've already changed the crankshaft sensor, candles and wiring but it is still the same.

Ya tiene bomba y sensor nuevo

P0158
Oxygen Sensor Circuit High Voltage (Bank 2 Sensor 2).

Check engine light - OBD P0031
What us the fuse # for the sensor.

My car remains accelerated in High. I have already changed the oxygen sensor and needle but the problem is still there.

Low voltage mass airflow sensor

My truck 2018, Toyota Tacoma, 2.7 L is stuck in Limp mode. My input input speed sensors aren’t receiving any power. I was wondering if anybody had any experience with that or any pointers.

Code P2432 not battery not O2 sensors not air injection pump

Resulta que le cambien sensor de velocímetro pero Aún las millas siguen congeladas no pasa De el millaje

Changed the tires and the sensor is either coming and going

Where is the MAP sensor on my Toyota Tacoma 2002?

L replece speed senser chek ing ligth on velosimetrer is workin what is the best wet to trouble shouting

Truck runs fine then bogs down and can’t give it gas then dies might start back and run fine for a week maybe two then does it again track light comes on and engine light I’ve replaced both fuel pumps crank sensor fuel regulator and fuel control module

My auto on lights are not working. Cant locate the sensor or which fuse controls this function.
Any guidance greatly apreciated. I am not a handy man by any count.