Problèmes Computer
Computer: Engine Control Unit. It regulates all the aspects related to the engine's proper functioning.
Lire la suite
Problèmes plus spécifiques :
Problèmes liés :
Voir le manuel du propriétaire
Meilleurs problèmes
Crank no start
Nissan Titan 2008 5.6 SE V8 4x4 60000 km
ECU is not responding, the shop had it for 2 weeks and could not figure it out. Getting power from the ipdm but not the ECU. Good solid crank but no start
2 signalements
JI
When testing resistance on the CAN bus, make sure the battery is disconnected first. Harness side (with IPDM unplugged): ~120 \Omega across CAN-High and CAN-Low. This measures the remaining terminating resistor in the network (at the ECM). IPDM module side (pins on the IPDM itself): ~120 \Omega across the CAN pins, as the IPDM serves as a terminating module on Nissan V-CAN systems. Entire network plugged in: ~60 \Omega across CAN-High and CAN-Low anywhere on the bus (measured at the OBD2 DLC port across pins 6 and 14), because the two 120\ \Omega terminating resistors operate in parallel.
Voter utile
CommenterNo breaks after bleed
Nissan Titan 2008 Nissan titan 256000 km
My breaks went out after bleeding I even tried to reset with computer
But there still going to the floor I don't know what's wrong
But there still going to the floor I don't know what's wrong
Des problèmes avec ta Titan ? Partage-les
