Problèmes Sensors

Sensors: Electrical device that measures the different performance parameters of the car.
Lire la suite
Problèmes plus spécifiques :
Problèmes liés :

Meilleurs problèmes

Location of 02 sensors

Mercury Milan 2006 Mercury milan 3.0 185000 km
My car keeps stalling and the code reads bank one sensor 2 and bank two sensor1 both codes come up
Kathy de États-Unis il y a 2 ans  
KA
1 réponse 
BigBoy de États-Unis il y a un an
I get the bank one sensor 2 and I have the part I just problem finding it
Commenter

Crank but won't stay running

Mercury Milan 2008 Premier V6 3.0 146204 km
My car got broken into the stolen my stereo in the app as well as my battery and everything from the throttle body down. I have replaced my battery, air intake system, mass airflow sensor, starter, spark plugs, manifold gaskets and the fuel pump. I had to reset the fuel pump shut off switch, and thr car finally turned over but then died. Almost as if it was starving for fuel however I have 60 to 70 psi at the fuel rail. But it almost sounds like a vacuum leak, which I've been unsuccessful in finding one. Also when cranking the car and pushing on the gas pedal it's like the pedal is not even working, it had zero affect on it at all. But when the car is off and I push on the pedal u can hear it in the throttle body. Help I'm at a loss...
MissQT75 de États-Unis il y a 3 ans  
MI
Rank 6
5 signalements 
MissQT75 de États-Unis il y a 3 ans
I'm at a complete loss please somebody anybody help me
Batchiball de États-Unis il y a 3 ans
I had this same problem and it ended up actually being a vacuum seal. Make sure to look under your Air Intake system, there’s a tube that attached to the bottom of your throttle body. Mine came loose when I was messing with it and it did exactly what you explained. After i got the tube back in though, everything worked fine.
MissQT75 de États-Unis il y a 3 ans
Thank you when I get off work today ill check it out. Does anyone have or know where I can get the wiring diagrams for my car?
Cokernuttt de États-Unis il y a un an
Same issue here same car I have replace fuil and pump
Commenter

My ABS light is on, or as it was called on this vehicle, System Track

Mercury Milan 2010  74888 km
ABS light is on, on the dash. I replaced both sensors, and made certain wheel bearings are solid. I also checked the gears that the ABS reads, and they are clean... What else could be the problem?... Strangely enough, and I can not make this up, but in colder (icy) weather and rain, the ABS starts working again. During the hotter months it stops and stays off. What could cause this?
Christian de États-Unis il y a 2 mois  
CH
Des problèmes avec ta Milan ? Partage-les
Envoyer le commentaireAnnuler
Envoyer la réponseAnnuler


Recherches populaires
RadioClutchOverheatingFusebox