Error code 67 appeared to me and, as I've read in the handbook, it has to do with the steering column. When turning of the car and opening door, a strange noise can be heard. I assume it is the steering wheel's lock. Does anyone know how to solve it?
The error code 67 is an error between the comunication of the bodywork module and the steering column one. In the steering column module there is a device that reads the steering wheel's position and, when reading it inappropriately, the bodywork module determines that its state is not the right one to start, nullifying this function. The problem is within the column module, where a latch locks or breaks. In most of the cases, the problem can be solved by hitting softly the steering column module, located right under the column itself and to access it you simply need to remove the underlying plasic, which has four screws. Others say that, only by moving the direction, when pressing the start button again there will be no inconvenients. Good luck!
If the noise when you open the door is longer than usual, you should take your car to some workshop because it is the steering column module that is failing.
The steering module device can be fix without going to any workshop if only you have the time to figure it out... you need to know what the steering module is it under the your car steering area inside, just lose it out and clean up the old grease inside and check if the small motor inside is okay if yes just it will work for you and the error will be gone once you complete this process. Make sure that you grease the device back before mounting it back good luck
Meu cruze LT eco tec 6 aut, ano 2012. Enquanto dirige ou parado ligado, ao virar o volante para ambos os lados el faz um barulho rangendo e estralando na frente. Parece que vem das torres dos amortecedores. Já troquei tudo na frente, menos amortecedores, pois o mecânico disse que estão bons. Mas o barulho permanece. Horrível!
Qual o suposto problema?
First hi beam relay stuck light not going off, then horn not working same with wiper. All fuses and relays working, All ground from fuze box ok. All good up to fuse. What's wrong.
My Lock Module does not work on both the key fob and inside the vehicle panel. When I press from outside on the unlock button on my key fob I can see the lights on, but the system does not unlock the car. I know that the anti-theft lock module is located behind the inside mirror. I don't know exactly what the root cause is: lock module or anything else? how can I test the lock module to know if it is working properly or not?
Windows won't work from driver side window control. Dom light won't come on when the door opens. But the lock goes up and down on the door when the button his hit. Window and dom works with all other 4 doors
Qual o suposto problema?