SolvedBurn smell when I set the heater blower to #3,
Ford Mustang 2006 mustang gt 117650 miles
Burn smell when blower is on #3. I already changed out the blower motor, resistor and pictail connector wire. I recently replaced the Relay mod for the blower motor but I have not evaluated the issue for improvement yet. Is there any other suggestions that I can consider before replacing the Resistor again? Please advise.
1 report
Best answer (according to Jacob)
JA
I'm still 'not sure' if I fixed the issue yet, but so far I haven't detected any new burn smells when switched to 3. I think the Relay was the best fix of all, but no one even suggested that as the remedy. I spoke with many experts before acting on it and only spent $12. On the replacement and installed it myself. Shop charges of $150. Were avoided.
Vote helpfulJA
See my reply and findings
Vote helpfulRelated problems
Blower motor not working
Mustang 2008 V6I've checked the motor, hooked it up to power and it works. I changed the resistor, I've checked the relay, the control switch. Im not getting not speeds on air flow. Any one got any suggestions?
Heat and AC
Mustang 2014 5.0Blower works but no heat or ac
Ac not working blowing only hot air have changed filters n checked
Mustang 2012 V6 Compressor n blower all working fine put Freon in it as well
I need to change the blower motor resistor
Tacoma 2012 Pick upChange the blower motor resistor
Blower Motor Not Starting
Fusion 2012 Hello,
In my car, the Blower motor is not starting. I tried to check the blower motor directly using the battery and its working. But when I am trying to start from the blower motor resistor it's not…
No a/c do to the fact the blower motor resistor is bad. The Diode blow
F-150 2001 TritonBlower motor resistor module keeps going out. Replaced resistor 3 times/ Blower motor once. With new resistor it works for a week
1 reply
