Sounds like an issue with that stupid fuse that is attached to the negative terminal on the battery. I’ll take a picture tomorrow for you to see what I’m talking about
AC does not blow cold air when turned on. I had a new blower motor installed in the front because heat was not working either. Heat is now working fine but the air still is not. Could it be simply a fuse. ? If so, is it located inside the car or under the hood ? When the air was working, it was not coming thru the center vents or rear. Are there separate blower motors for those sections too ?
Ipdm circuit board was burnt (no start). I ohmed out the burnt spot on the board to 2 connectors (a cm and a cn outlet on the Ipdm). I ordered and installed a new Ipdm, and it starts, but I am getting 30 dtc codes, and the ABS and a/c compressor are not working. Im trying to figure out where the branch circuits from connector cm and cn go. I am beginning to think it’s ecm that burnt up.
I don’t have that issue but have same exact year make and model. Your first person I’ve come across that does. But trying to figure out why crankshaft sensor code keeps popping up after replacing it and why car is running crappy. Tried resetting codes etc, stumped
Rear over head A/C is not working and even the cargo space I believe. but the a/c from the center console for the 2nd row seat is blowing air but not enough to make the back seat comfortable. what might have caused this?
btw. the lights on the knobs for the rear controls are working.
When my car is driving for a while or I turn my a/c on my RPMs bounce up and down and then loses power . When I shut it off and turn it back on it keeps going for a couple miles then does the same thing . The car has had a cat delete as well
A/C stopped working and most of the dash trouble lights left side lite up. Corrected a (P0300 code 8 - random/multiple cylinder) all 8 sparkplug coil packs changed, engine running better than normal.
Need additional troubleshooting before I take it to a repair shop.