Crankshaft problems
Crankshaft: Spinning mechanical piece that receives the movement of the pistons and transmits it to the gearbox.
Read more
More specific problems:
Related problems:
See owner's manual
Top problems
Problem with fuse box wires that fall off after manipulation
Toyota Corolla 2008 gasoline, automatic transmision, 1zz-fe engine, 1.8L 99999999 miles
I have a problem with the fusebox, im having problems with my toyota corolla 1.8L year 2008 1zz-fe engine with sensor like crankshaft, camshaft, ignitions coils, vvt valve, and i change all of them, and it works fine, but in all that maintainance work, the engine fusebox was checked and with the manipulation the car start getting problem and stop working, it cranks but wont start, and doesnt light the check engine alert, so the car computer doesnt get electric current, so checking the underneath wires i notice that some cables are loose and a bunch of white wires with black line fall off, the… Read complete
1
2
1 reply
CA
The photos posted are for reference only, to show the cables that fall from the fuse box block
Vote helpful
CommentThe engine trips off immediately the AC is put on
Toyota Corolla 2004 74000 miles
The crankshaft was replaced and since then, whenever I put on the AC, the engine trips off immediately. We changed the crankshaft to anotger one and the problem still persists. I was told the pressure in the engine is too low but I don't know what that means
1 reply
Juggernaught from New Zealand 9 years ago
Try checking these and see if that helps route the problem you might be facing;
Battery test (Depending on size you might want to up-size), up the mixture (Carburetor) to Rich not lean or check the mixture its lifting (Fuel Injected), check spark and leads, AC fuses (Both exterior and interior) Ultimately get a full diagnosis done by Mech and Tuners in your country; you may have a wiring problem (Highly unlikely) but pressure you will need to know mixtures between Carburetor and Fuel Injected, hope that helps.
Battery test (Depending on size you might want to up-size), up the mixture (Carburetor) to Rich not lean or check the mixture its lifting (Fuel Injected), check spark and leads, AC fuses (Both exterior and interior) Ultimately get a full diagnosis done by Mech and Tuners in your country; you may have a wiring problem (Highly unlikely) but pressure you will need to know mixtures between Carburetor and Fuel Injected, hope that helps.
CommentCar always stop
Toyota Corolla 1998 Sedan, 1.6L, automatic 1000 miles
My car always stop engine when I drive for long like 1hr. We have replaced, cold start sensor, coil injectors, fuel pump, fuel filter, crankshaft and ignition switch
1
Car has Code P0016,
Toyota Corolla 2010 1.8 170000 miles
Car was Running in perfecto Condition, and all of the sudden Car Last the power engine turn Off and not eable to Start, after trying and traying the car star and I was eable to get home,
At home I Scan the Car for Codes and I had a bunch of Codes, P0343,P0102,P0113,P0011,
P0340,P0016, all Codes are related to Timing, Crankshaft Sensor and Camshaft Sensor not Sincronising and Vvt solenoids being in Open Circuit, the Car is stable on Idle at 900 rpms,but when you put it on gear "D" it starts runing nice but after first shift it loses power and it would go slowly getting speed, I alredy ch… Read complete
My Corolla runx shape doesn't start the engine.
Toyota Corolla 2005 Corolla runx shape 90000 miles
My car was service to change Oil pump and crankshaft, from there my car do not want to start at all, it only turn the engine.
Problems with a Corolla? Share them
Find what you needed?
Thank you!
