Left rear tire, sensor its not working

How do I splice in a new 5 wire pigtail into throttle body sensor

How to change them and location of both

I have code for evap solenoid permanent fail and a second code for same thing pending. Replaced sensor at TB and at charcoal can,twice. Sensor at TB rapidly opens and closes . Can't check resistance. Could this be the PCM?

Shoes low fluid all the time

My van's fans are suddenly turned on and the temperature's pressure gauge is disabled. On top of that, a script warns that there is an engine overheating. The thermostat and temperature sensor were replaced, it worked better for two months but the problem is now back. What might it be?

Running rough. Feels like fuel filter. Or pump. Are both in my gas tank? Or could this be a sensor?

Hi, I've been noticing some engine power loss in my van lately. I've change the air filter, its holder's lid where the sensor is located, I've cleaned the sensor's wet connection and the vehicle keeps failing. I have then disconnected the negative pole for a while and the problem was temporarily solved. After turning the engine on and off, the failure returned and now there is nothing I can do to take it away. Can someone give me any idea or solution? Thanks!

Have a 2007 Chevy Silverado and I’m dealing with a bucking/jerking issue when driving. When I first start the truck cold, it runs fine with no problems. But after it warms up, it starts bucking, especially when shifting gears or accelerating. There are no check engine lights and no transmission codes showing. I’ve already tried unplugging the purge valve — when unplugged there’s no suction, but when plugged back in it pulls suction like normal. The truck idles fine and can cruise at highway speeds (70–75 mph) without major issues, but the problem shows up more during acceleration or gear cha… Read complete

The crash indicator light stays on, there is no obstruction on windshield in front of the sensor. This disables crash warning as well as auto dimming headlights and drive assist functions.

Got in my vehicle and the adaptive cruise control unavailable light popped up along with saying the collision sensors are unavailable. I’ve cleaned the camera and turned it off and all the suggestions I found online. It’s been doing this for two weeks now.

My truck backfired and died while in motion, it restarted after a minute but i drive another mile and stopped and turned it off and now it will not start. It turns over strong, had fuel coming thru the fuel rail, i just replaced the ignition control module, the ignition coil, the distributer cap, the rotor, and the cam shaft position sensor after this happened a week ago and a week before that as well.
When i add fuel in the carb manually it still won't even fire. What could be the problem?

I’ve been working on this truck for a while now and I’ve managed to fix all problems that my check engine light reports. There is no longer any check engine lights but I’m still experiencing some problems. When ever I’m in a parking lot about to reverse park, my truck will suddenly cut its self off. I am also experiencing some poor engine responses as well as delayed acceleration. I’ve replaced spark plugs/wires, all O2sensors, EGR value, air filter, and gas filter also have done a gas treatment.

Good morning have a 2010 Chevrolet Silverado Crew Cab 1500LT 4.8L 2wd. Truck has 6 inch lift, . Ok truck started driving sluggish. Well 2 years ago had truck diagnosed with misfire on cylinder 7 low compression, , truck transmission started slipping , then I would drive normal speed and then came to a stop light and truck barely moved. Well I had it rebuild and cus it wouldn't move when put on drive, after going from park to reverse everything fine, but once you put it on D , nothing, driveshaft no rotation, Well also put in a new used engine 5.3L and after swap drove truck along the blo… Read complete

My ABS and traction control lights come on the the truck goes into limp mode. But it does not give a check engine light. I have replaced the accelerator pedal sensor once before. I believe it could be the wheel speed sensor

Noticed brake lights going on and off while driving while driving for the first couple miles and then they go back to normal operation. Only noticed this once the weather got cold. Then a new symptom developed as the brake lights come on while the truck is off and stay on long enough that it killed the battery. I replaced the brake pedal position sensor and re-calibrated it. Did not fix it. Got another one and did it again just in case. Same problem. No change. Truck is parked for the winter so if anyone has any ideas it would be great to get it fixed before spring.

Replaced both knock sensors and harness.
3 week later light came back on.

Scanner says heater is defective. Do I need to replace the sensor?

Let me start by saying I replaced mass air flow sensor and fuel pump so far but the issue still occurs when I start the truck in the mornings it acts like it's not getting enough fuel but once it's started it idles and runs just fine if I start it soon after it starts fine as well only does that after a few hours of sitting. Anything you all recommend to check other than fuel injectors as those are gonna be tested today?

No crank no start and under list of live data sensor supply relay malfunction will not clear from scanner. I have changed relays changed starters twice. Checked the board of the fuse panel under the hood for three weeks.

Good day, I have had to replace CTS(coolant temperature sensor) (several times) and thermostat(once) in order to stop my radiator cooling fans going off full blast and not turning off after shutting engine off. I have enough coolant; truck does NOT have relay for fans, it has fuses, and they are good. Please advise at convenience and thank you.

Going to replace all 4 heater sensors, not sure where the knock sensors are or what they do and how to fix, and the knock sensor 2 low circuit input (Bank 2)what and where is that and what is the fix, any help is appreciated I have a helper that is kin to Google, Sir, Alexa and whatever the other names are and not getting anywhere

How do I shut off the tpms light in my truck. The sensors are gone, I got it that way.

Hey guys, were having some issues sith our 2004 5.3L silverado. Rear end blew 4 days ago, chamged that. Now since than its been reving and lagging when it shifts gears, and wont shift into OD/4th gear. Its got the 37:3 gear ratio for the rear end and. Now today, as we were pulling it out of the yard (it was still in first at the time) something make a loud TING CLANK sound and all of a sudden we have nothing but 1st 2nd and reverse gears. Not sure if this issue is due to a sensor, or if the tranny/ transfercase is not shot after the rear end let go last week. Any help is very appreciated. Im at a loss and this truck is becoming my worst nightmare. Thanks!!