All tires are all good but tire sensor keeps on

Cómo reprogramar los sensores de presión de aire nuevos

Ubicación del sensor de cigueñal

The car will crank, but immediately goes into limp mode with Service Stabilitrak/Reduced Engine Power flashing on the dash. It also does not do anything when you press the gas. I have tried replacing the throttle body, gas pedal with the position sensor, and checked all fuses. The only other thing would be the ECM, but a friend of mine tested the ECM and said it was fine.

The engine starts but there is too much fuel moving to the cylinders, and it is fuming way too much, black fume suffocating the engine. I've changed the refrigerant sensor, it worked properly for an hour and the problem returned. I have then installed the original one, it worked fine for a while and failed once more. When it fails, the rpm tachometer drives crazy.

Bueno amigos. He cambiado pedal de acelerador bomba de combustible cuerpo de acelerador sensor maf y el problema persiste. El camaro. No acelera a más de 2 mil revoluciones ni andando ni en parkin

My Camaro z28, 1997 suddenly does not start. The engine begins running but won't finally start working. Coils and the crankshaft sensor have been checked but everything seems to be alright. There is no spark in the spark plugs, and I was told it is the computer that is failing.

My car was left unstarted years and little to no gas in it with a leak in valve cover gasket but also muffler fell off and had to unplug the oxygen sensor.

Car is not kicking on fans when temp sensor is unplugged fans go full blast, replaced all relays...fuses... connector on fans are perfect fans sound fine when temp sensor is unplugged( full blast) guage working... next is to replace whole fan unit...FML
Any feedback on testing fan control module , has almost overheated wiring issue?

Hello together, I owned a Chevrolet Camaro in September 2022 and just got problems over problems since February 2023. I hears unusal noises, coming out of my engine. I thought it would be a connecting rod bearing damage. Nobody wanted to fix the engine. After weeks of search, i just found a workshop who want to fix it. The workshop replaced my timing chain, cause they thought it will solve the problem. After picking up my car and driving only like 20 miles, the car wouldnt start anymore. After that the workshop find out that the crankshaft is broken and i also got a connecting rod bearing d… Read complete

At 1000 rpms it goes to over 7000 rpm,
Temp gauge passes the top while driving and sticks. Car also dies when stopping ( possible map sensor bad). Code 34 getting part tomorrow. Checked grounds look good.

There is no spark. I've already checked the optispark and crankshaft sensor and they are both alright. The coil and ignition switch are working properly just as well. What might it be? Does the crankshaft sensor send the signal to the optispark, then to the ignition switch and finally to the coil or how does it work?