Computer problems
Computer: Engine Control Unit. It regulates all the aspects related to the engine's proper functioning.
Read more
More specific problems:
Related problems:
See owner's manual
Top problems
Crank no start
Nissan Titan 2008 5.6 SE V8 4x4 60000 miles
ECU is not responding, the shop had it for 2 weeks and could not figure it out. Getting power from the ipdm but not the ECU. Good solid crank but no start
2 reports
JI
When testing resistance on the CAN bus, make sure the battery is disconnected first. Harness side (with IPDM unplugged): ~120 \Omega across CAN-High and CAN-Low. This measures the remaining terminating resistor in the network (at the ECM). IPDM module side (pins on the IPDM itself): ~120 \Omega across the CAN pins, as the IPDM serves as a terminating module on Nissan V-CAN systems. Entire network plugged in: ~60 \Omega across CAN-High and CAN-Low anywhere on the bus (measured at the OBD2 DLC port across pins 6 and 14), because the two 120\ \Omega terminating resistors operate in parallel.
Vote helpful
CommentNo breaks after bleed
Nissan Titan 2008 Nissan titan 256000 miles
My breaks went out after bleeding I even tried to reset with computer
But there still going to the floor I don't know what's wrong
But there still going to the floor I don't know what's wrong
Problems with a Titan? Share them
