Replaced intake twice do to STUPID COOLING WATER inlet design flaw. None OEM parts are generally JUNK & DON'T LAST ! especially from China! EG: power window regulators , sensors , +++.
Install wiring from Kenwood radio on Town car 2006 Cartier with Alpine system to power amplifier in the trunk which I believe needs to be reduced to 5 volts, using original factory speakers. Need specific wire colors and location, please.
The best fix for your suspension is to replace it with regular suspension. The air is expensive and a pain to maintain. Once you switch over, no more suspension problems...forever...
Check the fuse and test for power at the connections you made to make the compressor operate.No compressor, no air bags get inflated. Also, test the level control that limits the rise at the center of the rear axle. It has a lever to actuate it. Guscars.
No. It's always easier to test and repair those windows mechanisms than find a new door with a mechanism that works, maybe for a short time, remove both doors, install the new one and paint to match. Makes no sense to go through all that, for the cost of a motor or a new mechanism with guarantees.
Might be the blend door actuator. That's What opens or closes the floor, defrost or cabin air flow inside the cabin. Search and Read online about how to determine the reason for your problem.
Hello all, my 99 Lincoln town car, the headlights, turn signals, hazards, and brake lights all work. However car when I put on the headlights, no tail lights come on. When I put the switch to running light position I get no running lights on in the front or rear. Any thoughts on what my issue could be?
I Wana had a kill switch to the fuel pump but idk wat colors r the power or ground i wanted to split the wire n add the kill switch in the trunk does any one which color is the power n ground or wer is a good spot to run it out of
In the trunk, the inertia switch which cuts power to the fuel pump has 2 wires. Red is the 12v. , so cut it and add a wire to each end of your cut. Bring those 2 new wires and add a toggle switch at those ends to interrupt power on the Red wire and hide it somewhere you can reach inside the cabin. Guscars
Tip: Because these are LEDs, your car might "hyper-flash" (blink very fast) because it thinks a bulb is out. You may need to install a load resistor or a compatible LED flasher relay to fix this.