I can't even get it to start with a jumper box

My ac isn’t blowing from dash vents only from defroster no matter what setting I set it to. How to fix??

Won't start after hooking up subwoofers or at least trying to.

Dash lights don't work at all

I want to hire hardwire a dash camera from inside of the unit right side key panel wanna know which fuse is always hot and the fuse for the ignition and the last wire will be for the ground

I have a 2007 mustang 4.0 with issues, i have tried everything i know i am at a loss at this point... PLEASE HELP. Went to work and went to store before home and battery was dead had to be jumped, on the way home my gauges went haywire and car switched off and on while i was driving. It died on me just as i pulled in to yard. Checked fuses GOOD changed Battery GOOD. Changed Alternator GOOD Went to work next day it died on me on my way there. Jumped it off got it home now it wont crank at all. I have an odo dte fuel level error and odo fei dte error and check charging system. I bought this ca… Read complete

I was driving and all day and i cut vehicle off and when i went to start the vehicle it act like it was going to start it was like a quick vrrgh then went quiet my car is a stick manual transmission so i pop the clutch and the car started. So i figured it was the starter so i went out and purchased a new starter and put it on, and when i went to go start it same thing nothing and yes i put the starter on correctly. I check all fuses and there all good now i can't tell if relay is good or bad because the relay is all black. When I put the key in and turn the key all the lights on the dash come and everything but at that last turn i get nothing ,so I'm asking what could it be.

I swaped the motor and transmision with the same year but it wont crank or start. The odometer reads mileage when you first turn the key over for a second but switches to dots.

I pulled the old battery off for about 5 day's. Replaced with a newer one, and my issue is it won't turn over ,When I turn the key on all the lights on dash is on including theft light I checked connections and tested relays and checked every fuse. Still won't crank. In leaning towards anti-theft or safety switch in the shifter. Any in put would be a great help. It's a 2006 v6 mustang.

While driving car runs fine when I come to a stop or red light engine shuts off but restarts when I start it

I recently bought a 2014 Mustang V6. The check engine light is on, and when I scanned it, it showed a crankshaft position not learned code. I already changed the crankshaft sensor, but the problem persists. The RPMs fluctuate when the car is stopped, and it feels like it's about to shut off. Also, it doesn’t accelerate properly—it takes a while to respond. Could you help me figure out what the problem might be? Thanks!!

I am try somethings but has still say check inlet or something

Wiring issues and and wrench symbol light appears on dash after water leaking on interior fuse box. There’s a new smell, possibly burnt electronics while driving and it idles slow and dies

Starter relay stays engaged even after I start the car

The brakes are stuck on,radio controls and ac /heater controls isn't working, temperature on radio screen isn't computing, turn signals isn't working on the outside but flashing out of sync on the dash. This happens periodically, then go back to normal.

Brakes will do fine for a few days and then release after stops consistently slower until they simply don't let go. Tow it home or to the shop and let it sit for a few days and fine again. There have been two separate occasions where the collision prevention system randomly activated and it stored codes. It said hill assist unavailable and abs fault. Took it to the dealership and they charged me $250 something to put it on the diagnostic machine and tell me it's the rear speed sensors and the purge valve for the evap canister. Fixed all 4 speed sensors for good measure and the purge valve. Sti… Read complete

I’m having a lost of communication with abs module and a bunch of wiring lights on the dash

Dash cluster not working oil pressure temperature

Put in an older battery to see if the car would charge it and went to get on the interstate got on it a little bit car shut down completely road to the side we put the original battery back in car started up only the speedometer would not work after that cannot figure it out

We regularly drive our 2005 Mustang GT Convertible. For a few years, we have had issues with the convertible top going up and down. At the suggestion of service department at the Ford dealership, we replaced the convertible top motor. This did not fix the issue. We brought it back and they were stumped. We brought it to another Ford dealership, and they told us that the alternator was not providing enough power to put the convertible top up and down. We had the alternator and battery replaced. Brought the car home, and it didn't go up. By chance, I replaced the 10 amp fuse for the convertible… Read complete

Car died on your interstate do turn old battery put new battery in car started and now speedometer don't work

Can't fine the issue with this code. Replace transmission position sensor but still have O/D off flashing. Check engine light on and car in limp mode. Any help would be appreciated

A/c isn’t working and the cluster says it’s overheating but its not fans are kicking on and off compressor is kicking in and off but not constantly

So i changed out my ignition cylynder when i noticed the key was getting stuck. Now after taking out the old one i am having trouble putting in the new one as well as the gear and retainer. The car has no power despite it having a brand new battery. The only thing that even makes a sound is the door chime! lol please help i just want to drive my beautiful car again...

I parked the car for a year but now its not changing gears and it turned on the OD drive lite on the dash

Getting up to speed the car will shift to 2nd and then keeping the acceleration up, it wont shift to 3rd unless I let off the accelerator, then it will go into 3rd, and then it flashes the engine light and will run like shit for a little bit, until the light goes off and will be back to normal, until I kick it down again.

I have replaced O2 sensors 3 times this last I got some good ones what is funny in my code reader it shows green for smog ready but show there is a problem with that sensor I have traced every wire in it how I know there is a short I disconnect the negative cable and put a test light on it the. I out the light on the post and it lights up not to bright so I kinda stuck although I can't get to too if the transmission to check for broken wires plus have a new pcm gie it need to find someone that know what they are doing she run great I. An not get rid of the check engine light and in the live data b2s2 reads 0000rhe other ones read 99.90 when at temperature

I accidentally flipped the terminas when jump starting my vehicle. The main fuse blew up and I replaced it. But the steering wheel buttons do not light up, they're working but not lighting up even when i switch on the headlights manually (not uing auto), this also applies to the (traction/hazards/trunk) button. Every single button in the car works and lights up, but these buttons work with no back light.
I tested the fuse box, some fuses were blown and got replaced, and i did test the fuses after replacement to check if something blew up again due to a short circuit, but its all okay.

I decided to mess with the fuse box one day and unfortunately pulled a couple of fuses that I didn’t know what they were or if they were long story short, the car won’t start the battery charges. The key turned over and the dashboard lights come on you can run on the windows, etc. but the car will not turn over. It makes a clicking sound and somebody said that we needed a new what was it called Something new but I bought the parts. Just wondering if anybody had any suggestions

Hi everyone! I recently updated the sync 1 module in my 2018 ecoboost to sync 3, and my car suddenly got into a no crank no start situation. There analog gauge is not showing anything, and when I press the start button there is a small click sound but nothing else. Sync module can still start with engine off. I charged the battery in full but still got the same issue.