Engine heating
Peugeot 306 2001 243000 miles
The engine, dashboard and windshield warm up and a lot of hot air comes out of the heater grid. I've cleaned the radiator, installed the hose and added pressurized water. I've also changed the water and removed the thermostat. But nothing has changed. Might it be the water pump? There is no strange noise and the temperature gauge looks normal. What can I do?
1 reply
CO
If you removed the thermostat, you should check that the engine cooling fans turn on when the temperature reaches 70/80 degrees. If they do not activate, you need to do the following: turn the air conditioning and check if it works; turn it off and disconnect the temperature sensor. If it does not work, between the two engine cooling fans, and behind a triangular lid, there are three relays, which you need to check. If the relays are alright, then there is a problem in the temperature module.
Vote helpfulRelated problems
Problème de faisceau
306 1998 Problème de d installation
Heating air inside
306 2006 Peugeot 308 1.6Internal heating seems not working anymore, even of at the maximum level
Dashboard failure
306 1998 A while ago, I was having problems with the fuel tank and now, from one moment to the next, the dashboard stopped working; only the temperature is indicated because the speedometer, revolution gauge,…
1 replyOver heating
Silverado 1500 2003 5.3changed thermostat and water pump no change at all and no obvious water leaks
1 replyOver heating
Cavalier 1998 My car is over heating. I changed the reservoir the water pump thermostat flushed the radiator checked the fan checked the hoses for leaks and it still runs hot
2 repliesOver heating
Nitro 2007 4.0 rtI put in a new water pump radiator and thermostat and thermostat house it over heats fast I flushed the radiator no blockage water still boils back out
1 reply
